Structural Concepts Fusion GHSS860RLB handleiding

Niet gecategoriseerd

Structural Concepts

37 pagina's

PDF beschikbaar

Handleiding

INSTALLATION, CONT’D: DISPLAY CASE START-UP (CASE / LIGHTS / TEMP. CONTROLLER / SST)

Cap

Plug

Receptacle

Raceway Receptacle, Plug and Cap

Raceway

20. Display Case Start-Up

A. Case

• Remote: Case will power-up when properly field

wired (or plugged in).

• Self-contained: Turn main power on.

• After case is powered up, lift curved or flat front

glass by grasping lift handle and raising (see

illustration at right).

• Note: Illustration at right reflects flat front glass.

Yours may have curved front glass.

• Lift deck to check that coil fans are running.

• Coil fans (and in self-contained units, compressor

motor) should turn on.

B. Lights

• Turn lights on.

> Switch is either at case front, attached to rear

plenum, above top shelf (as shown at right) or at case

rear (as shown at top-right).

> In cases with NO SWITCH, lights will come on

when case powers up.

• All lights should come on at the same time. If

bulbs are fluorescent, first time lighting may

require a short warm-up period. LEDs have no

warm-up period.

• Slightly dim / flickering of new bulbs is normal.

If lights do not turn on, check raceway plugs.

• Lighting is wired in series so all lights must be

plugged in or receptacles capped for case

lights to be on. See illustration at right.

• LED Lights: If lights do not come on, check that

plug is properly inserted into socket.

C. Temperature Controller (All Self-Contained

Units and some Remote Units)

• Check that compressor symbol light is on.

• After case has run for a few minutes, check that

temperature starts to drop.

• If temperature controller does not begin cooling

(in a few minutes) see temperature controller

section in this operating manual for instructions.

• Remote units (without temperature controller on

case): Verify that refrigeration requirements listed

on serial label (found on the case) are being met.

D. Saturated Suction Temperature (Remote)

• See serial label on case for suction temperature

requirements and BTU requirements.

• See serial label on case for defrost schedule and

temperature termination parameters.

Main Power

Switch

Light Switch (On

Certain Self-

Contained Units)

Temperature

Controller

Coil Fans

Raceway

Plugs (See

Illustration

Below)

Light Switch at Rear

Plenum Above Top Shelf

(On Remote Units and

Various Self-Contained

Units)

Self-Contained Unit Control Panel

(With Temperature Controller)

Bekijk gratis de handleiding van Structural Concepts Fusion GHSS860RLB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.