Structural Concepts Fusion GCD856HHLB handleiding

Niet gecategoriseerd

Structural Concepts

24 pagina's

PDF beschikbaar

Handleiding

CASE OPERATION: MAIN POWER / LIGHTS / THERMOSTATS / OPERATING TIPS / SHUTDOWN

1. Start-Up - Note: This Section Is For

Authorized Personnel Only!

• Control panel is at case rear. It may be

accessed by removing rear panel (no screw

removal required).

• Main power switch, lights switch and thermostats

are on control panel. Replace front panel after

energizing control panel

• Turn main power switch on to energize case

(heated deck, heated shelves and lights).

• Turn on light switch for case lights to come on.

• Caution! Deck, shelving and overhead lights are

HOT! Do not touch until case has been turned off

and allowed to cool for 45 minutes!

2. Pre-Cooking Food / Checking Food Temp.

• Caution! Food MUST BE cooked PRIOR to

being placed in the case. Food should be heated

to between 150 °F to 160 °F (65.6 °C - 71 °C)

prior to placing it in the case.

• Temperatures of all food products are to be at

140 °F to 165 °F (60 °C to 74 °C), for shelves

and deck.

• Food temperature must NOT be allowed to be

below FDA guidelines of 140 °F (60 °C).

• Use ONLY food probe to check product

temperature before placing it in case.

DECK

• DO NOT rely on case thermometer or

infrared thermometer gun!

• After product is placed in case, check product

temperature (again) after one hour to verify that

proper food temperatures are maintained.

3. Thermostat Settings

• Important! Default thermostat settings are set

at the factory. This case should rarely require

adjustments to thermostat settings.

• If thermostat settings need to be adjusted, see

Programmable Controller section in user manual.

• If temperature is adjusted, allow 20 minutes at

NEW settings to determine if product

temperatures are acceptable.

• Check food temperature again after one hour.

4. Operating Tips

• When restocking, place new product at back and

rotate older product to front of case.

• Display product expected to sell within 4 hours.

• Clean up residue immediately. Spills will harden to

surface very quickly!

5. Shutting Down Case

• Remove all product from case.

• Turn main power switch to “OFF” position.

• Allow case to cool for 45 minutes before cleaning.

• See Cleaning Schedule section in User Manual

for specific cleaning instructions.

Bekijk gratis de handleiding van Structural Concepts Fusion GCD856HHLB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.