Structural Concepts Elevate BD3632IS handleiding

Niet gecategoriseerd

Structural Concepts

28 pagina's

PDF beschikbaar

Handleiding

CONDITION TROUBLESHOOTING

Case Not

Lining Up

See INSTALLATION section in this manual for instructions on properly aligning case

(alongside other cases) and adjusting levelers.

Water Is On

The Floor

Caution! Water on flooring can cause much damage! Until cause is determined (and

repaired), follow these procedures:

• Use wet-dry vacuum (or mop & bucket) to remove standing water.

• Use ‘catch pans’ for water to drain into. Swap out regularly until case has completely

drained.

Check that the drain trap is free from debris.

Check that the drain hose/pipe is correctly positioned over condensate pan (or floor drain,

for remote units).

Check store conditions.

• To prevent condensation in NSF/ANSI Type II environments, maximum conditions are

to be 55% relative humidity / 80° Fahrenheit.

Check that condensate pan components have no loose connections.

Check that overflow condensate pan (if any) has its power cord plug properly plugged into

electrical box.

Check that overflow condensate pan (if any) is not malfunctioning. Its electric rod heater

should be heating up when case is energized.

Caution! Disruption of power can cause water to overflow pan and seep onto flooring

causing damage! Check that power to case is constant. Until power is restored, follow

these procedures:

• Use wet-dry vacuum (or mop & bucket) to remove standing water.

• Use ‘catch pans’ for water to drainage. Swap out regularly until drainage of case is

complete (or until power is restored).

• When power to case is restored, condensate pan should function properly and water

will no longer overflow onto flooring.

TROUBLESHOOTING (TO BE PERFORMED BY TRAINED SERVICE PROVIDER ONLY) - PAGE 1 of 4

Bekijk gratis de handleiding van Structural Concepts Elevate BD3632IS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.