Stihl SEA 20.0 handleiding
Handleiding
Je bekijkt pagina 33 van 240
Fault LEDs on the
hand vacuum
Cause Remedy
► Clean the hand vacuum.
Hand vacuum
runtime is too
short.
The battery is not fully
charged.
► Fully charge the battery.
The battery service
life has been excee‐
ded.
► Replace the battery.
17.2 Troubleshooting the Charger
Fault LED on Char‐
ger
Cause Remedy
Battery not being
charged.
One LED glows
red.
The battery is too
warm or too cold.
► Leave battery inserted in charger.
Charging starts automatically as soon as
the permitted temperature range is rea‐
ched.
The LED fla‐
shes red.
No electrical contact
between charger and
battery.
► Remove the battery.
► Clean contacts on charger.
► Insert battery.
There is a malfunction
in the charger.
► Do not use the charger and contact your
STIHL dealer for assistance.
There is a fault in the
battery.
► Do not use the battery. Consult a STIHL
dealer.
The charger
does not run a
self test.
The LED
glows green for
about 1 second
and then red
for about
1 second.
Electrical contact to
charger was briefly
interrupted.
► Disconnect the mains plug from the
power supply.
► Wait for 1 minute.
► Insert the mains plug in a wall outlet.
18 Specifications
18.1 STIHL hand vacuum SEA 20.0
–
Approved battery: STIHL AS
–
Weight without battery: 1.1 kg
–
Maximum air throughput: 1026 l/min
–
Maximum vacuum: 80 mbar
–
sample inspection
–
Length: 465 mm
–
Width: 113 mm
–
Height: 187 mm
–
Inside diameter suction hose: 29 mm
–
Maximum container capacity: 0.75 l
Consult www.stihl.com/battery-life for the respec‐
tive running time.
18.2 STIHL AS Battery
–
Battery Technology: Lithium-ion
–
Voltage: 10.8 V
–
Capacity in Ah: see rating label
–
Energy content in Wh: see rating label
–
Weight in kg: see rating label
18.3 STIHL AL 1 Charger
–
Rated voltage: see rating pate
–
Frequency: see rating plate
–
Rated power: see rating plate
–
Charging current: see rating plate
–
Maximum energy content of approved STIHL
AS battery: 12.5 Ah
For charging times see www.stihl.com/charging-
times.
18.4 Extension Cords
If an extension cord is used, the cross sectional
area of its conductors must meet the following
minimum requirements – depending on the line
voltage and length of the extension cord:
If rated voltage on the rating label is 220V to
240V:
–
Cord length up to 20 m: AWG 15 / 1.5 mm²
–
Cord length 20 m up to 50 m: AWG 13 /
2.5 mm²
If rated voltage on the rating label is 100V to
127V:
–
Cord length up to 10 m: AWG 14 / 2.0 mm²
–
Cord length 10 m up to 30 m: AWG 12 /
3.5 mm²
18 Specifications English
0458-006-9821-B 33
Bekijk gratis de handleiding van Stihl SEA 20.0, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Stihl |
| Model | SEA 20.0 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 27562 MB |
