Stiebel Eltron FCR 28/120 handleiding
Handleiding
Je bekijkt pagina 19 van 124
ENGLISH
www.stiebel-eltron.com FCR 28 | 19
INSTALLATION
Safety
INSTALLATION
7. Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
7.1 General safety instructions
We guarantee trouble-free functional and operational reliability
only if original accessories and spare parts intended for the ap-
pliance are used.
7.2 Instructions, standards and regulations
Notice
Observe all applicable national and regional regulations
and instructions.
7.3 Water connection and safety assembly
Notice
Carry out all water connection and installation work in
accordance with regulations.
The water inlet and outlet pipes of the cylinder in which the ap-
pliance is installed must be made of metal.
Metal parts of the cylinder that can be touched and that are in
contact with water must be permanently and reliably connected
to the protective conductor.
Notice
A safety valve is required.
The max. permissible pressure must not be exceeded (see chapter
“Specification/ Data table” and cylinder specification).
f Install a type-tested safety valve in the cold water inlet.
Please note that, depending on the supply pressure, you may
also need a pressure reducing valve.
f Size the drain so that water can drain off unimpeded when
the safety valve is fully opened.
f Fit the drain pipe of the safety valve with a constant fall in a
room free from the risk of frost.
f The drain connection of the safety valve must remain open to
the atmosphere.
8. Appliance description
8.1 Standard delivery
The following are delivered with the appliance:
- PG29 cable gland
- Fixing screws, corrugated washers
- Jumpers
D0000119253
8.2 Accessories
Required accessories
Safety assemblies and pressure reducing valves are available
to suit the prevailing supply pressure. These type-tested safety
assemblies protect the appliance against impermissible excess
pressure.
Additional accessories
A mating flange is available as an accessory.
9. Installation
Notice
For the installation of the appliance, the cylinder must
be fitted with a mating flange (see chapter “Appliance
description / Accessories”).
Notice
The control panel must not be thermally insulated to pre-
vent any excessively high temperatures from occurring
inside the control panel.
The condensate drain aperture in the control panel must
remain open while the cylinder is thermally insulated so
that any condensate that occurs can drip off freely.
f Observe the required torque values during installation (see
chapter “Specification/ Data table”).
f Always install the appliance horizontally with the cable en-
tries facing downwards.
f Always install the appliance with heating elements and a
protective pipe arranged in parallel. For this, use the screws
supplied. Realign the components where necessary.
Bekijk gratis de handleiding van Stiebel Eltron FCR 28/120, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Stiebel Eltron |
| Model | FCR 28/120 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 20189 MB |
