Sterling SPG-6 handleiding

Handleiding

1234567891011121314/ 14

Afdrukken

Je bekijkt pagina 7 van 14

INSTALLATION

ELECTRICAL SUPPLY

This Steamer was supplied from the factory with a cord and plug. The AC power requirements are listed on the Data

Tag located on the right side panel at the rear of the unit. Make sure the voltage at the supply receptacle is within

+/- 10% of the voltage listed on the unit’s Data Tag. Connection to any other voltage may permanently damage

your Steamer or cause premature component failure. This type of damage is NOT covered by the warranty.

GROUNDING

To reduce the risk of electric shock in the event of an electrical short circuit, this appliance must be grounded. The

unit is equipped with a cord having a grounding wire and a plug having a grounding prong, which must be plugged

into an outlet that is properly installed and grounded. Under no circumstances should the plug be cut or bent to t

a receptacle other than the one specied.

WATER CONNECTION

MANUAL-FILL

A Manual-Fill unit does not require any water line connection. Simply ll the cooking chamber with 2½ gallons of

water before turning the Steamer on and add water as necessary throughout the day.

AUTO-FILL (Connected)

The water connection location is on the back of the Steamer. The specications for the connection are:

1. 10-60PSI

2. 32-175°F, (0-80°C)

3. 3/4” MGHT Fitting

Use an NSF Approved appliance hose to connect from a spigot/shuto valve to the Steamer. It must also be

installed with adequate backow protection to comply with all applicable Federal, State and Local Codes.

NOTE: The Owner/Installer is responsible for the water connection of this appliance. The components required to

connect this appliance to a water supply are not provided.

IMPORTANT: Always keep the level sensing probes (located inside chamber under Trivet at right front) clean. This

will help to ensure proper working conditions.

DRAIN CONNECTION (FOR FIXED DRAIN PAN ONLY)

Run a hose from the drain pan to a funnel tting leaving a 1” (2.54cm) gap between the hose and the top of the

funnel. There must be slope in the drain hose towards the funnel or oor drain.

IN-FIELD MODIFICATIONS

Any in-eld modications made to this Steamer without written authorization from the Sterling Manufacturing, LLC

Engineering Department will void your warranty. Please call 800-426-4211, 8AM-5PM EST, Mon.-Fri. to reach the

Sterling Manufacturing, LLC Engineering Department.

HIGH-LIMIT SAFETY

The SPG6 is equipped with a High-Limit Safety Device to protect the unit from overheating. If the High-Limit

temperature is reached, the unit will completely shut down (no lights). If this happens, follow the steps listed below.

CLEAN THE INSIDE OF STEAMER:

1. Wait for the Steamer to cool

2. Remove the Trivet (cover over water reservoir) and clean the water level sensing probes (located at right

front of chamber).

3. Clean the water reservoir (bottom and lower sides of chamber).

4. Restart the Steamer.

If the problem repeats, call the Sterling Service Department at: 800-426-4211

STERLING MANUFACTURING, LLC SMCD - IOMSPG6100318

5

STEAMER

1234567891011121314/ 14

Bekijk gratis de handleiding van Sterling SPG-6, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Niet gecategoriseerd