Steinberg SBS-LI-210 handleiding
Handleiding
Je bekijkt pagina 32 van 166
Loc
Parameter
setting lockout
0 – parameter setting
lockout disabled
1 – parameter setting
lockout enabled
(0 – 1)
0
PASSWORD = 9
Displayed
message
Parameter
designation
Function
(setting range)
Factory setting
ndA
Alarm mode
0 – alarms applicable to
high temperature only
1 – alarms applicable to
high and low temperature
(0 – 1)
0
ndC
Temperature
control mode
0 – auto PID control
1 – bit value control
(0 – 1)
0
dE1
Bit value
control of high
temperature
deviation
If the actual temperature
value measured exceeds
the total of the
temperature setting and
value dE1, the appliance
stops the heater.
(0 – 100
o
C)
0
o
C
dE2
Bit value
control of low
temperature
deviation
If the actual temperature
value measured is below
the total of the
temperature setting and
value dE2, the heater is on.
ndT
Time mode
0 – time setting disabled
1 – hold the temperature
2– time countdown
(0 – 2)
1
Hn
Time units
0 – minutes
1 – hours
(0 – 1)
0
SPd
Steady
temperature
deviation
If the actual temperature
measured is higher than
value SPd or equal to the
temperature setting, the
appliance starts holding
the temperature.
(0.1 – 100
o
C)
0.5
o
C
SPT
Temperature
holding time
SPT = 9999 – continuous
(0 – 9999 s)
0
EST
Alarm duration
(0 – 9999 s)
60
Bekijk gratis de handleiding van Steinberg SBS-LI-210, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Steinberg |
| Model | SBS-LI-210 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 23117 MB |
