Standard Horizon HX320 handleiding
Handleiding
Je bekijkt pagina 19 van 60
Page 17
8.4.1 TRANSMIT POWER
The TX output power of the HX320 is set to high level (6 W
※
) in factory default,
and the “HI” indicator is displayed on the top part of the screen.
To change the TX output power:
1. Press one of the soft keys.
2. Press the [◄] or [►] key repeatedly, until [HI],
[MD], or [LO] is displayed above a soft key at
the bottom of the LCD.
3. Press the [HI], [MD], or [LO] soft key to switch
between HI (6 W (5 W)
*
), MD (2.5 W), or
LO (1 W) output power.
*
(5 W TX required in Some Countries)
8.4.2 TRANSMIT TIME - OUT TIMER
(
TOT
)
While the PTT switch is held down, transmission time is limited to 5 minutes.
This prevents prolonged (unintentional) transmissions. About 10 seconds before
automatic transmitter shutdown, a warning beep will sound from the speaker.
The transceiver automatically switches to receive mode, even if the PTT switch
continues to be held down. The PTT switch must rst be released, then wait
10 seconds before transmission may be started again. This Time-Out-Timer
(TOT) prevents a continuous transmission that would result from an accidentally
stuck PTT switch.
WATER ENABLED LIGHT
When the HX320 comes in contact with water a white light will blink to
assist retrieving it in low light conditions. The light will automatically turn
o in about 15 seconds when it is removed from water.
The HX320 has a menu selection to enable and disable. Refer to SETUP
Mode Item “STROBE LED (Water Hazard)” on page 39 for details.
Bekijk gratis de handleiding van Standard Horizon HX320, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Standard Horizon |
| Model | HX320 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5720 MB |
