Standard Horizon HX270S handleiding
Handleiding
Je bekijkt pagina 17 van 44
HX270S Page 15
Installing the Quick Draw Belt Clip
1. Connect the hanger to the rear of the HX270S, with the notch point-
ing directly up, using the supplied screw (Figure 6-a).
Use only the screw included
with the clip to mount the clip
to the back of the transceiver!
2. Clip the Quick Draw Belt Clip to
your belt (Figure 6-b).
3. To install the HX270S into the
Quick Draw Belt Clip, align the
hanger with the Quick Draw Belt
Clip and slide the HX270S into
its slot until a click is heard.
4. To remove the HX270S from the
Quick Draw Belt Clip, Rotate the
HX270S 180 degrees, then slide
the transceiver out from the Quick
Draw Belt Clip (Figure 6-c).
5. OPERATION
5.1 INITIAL SETUP
1. Install the belt clip on the transceiver, if desired.
2. Install the battery pack on the transceiver (see
figure 1 and section 3.2).
3. Install the antenna onto the transceiver.
NOTE
Water resistance of the transceiver is assured
only when the battery pack and antenna are
attached to the transceiver.
Figure 5
Antenna Installation
Figure 6
(a)
(b)
(c)
belt
«
HX270S
Bekijk gratis de handleiding van Standard Horizon HX270S, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Standard Horizon |
| Model | HX270S |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3449 MB |
