Stairville All FX Bar handleiding
Handleiding
Je bekijkt pagina 15 van 32
7 Operating
7.1 Switching the device on and o
1. Verify that all required laser safety precautions have been taken. Make sure
that there is no one in the reach of the laser beam.
2. Insert the safety key into the lock.
3. If not already done, connect the device to the mains.
4. After a few seconds, the fan and the motors start to work. The display shows
the current version number of the device.
ð
The device is operational.
5. Turn the safety key to the ‘ON’ position to turn the laser beam on.
1. Turn the safety key to the “OFF” position to turn the laser beam o and remove
the key. Keep the safety key in a secure place.
2. Disconnect the device from the mains.
7.2 Operating mode Automatic
This setting is only relevant if the device is not controlled via a DMX controller and
not working as slave in a master / slave conguration.
1. Press [MENU] repeatedly until the display shows ‘Aut’ and conrm with
[ENTER].
2. Press [UP] or [DOWN] to select one of the automatic programmes
‘Au01’ … ‘Au14’ .
3. Conrm the selection with [ENTER].
ð
The selected automatic programme is played back immediately.
4. Press [ENTER] again to open the settings menu for the programme run speed.
5. Press [UP] or [DOWN] to set the programme run speed from ‘S 1’
(slow) … ‘S100’ (fast).
6. Conrm the selection with [ENTER].
7. To return to the main menu without making changes, press [MENU].
Switching on
Turning o
Operating
All FX Bar
15
LED Eect
Bekijk gratis de handleiding van Stairville All FX Bar, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Stairville |
| Model | All FX Bar |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2667 MB |
