Stairville All FX Bar handleiding

32 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 11 van 32
NOTICE!
Risk of overheating and re due to inadequate distance and bad
ventilation!
If the distance between the light source and the illuminated surface is
too short or the device is badly ventilated, the device can overheat and
cause res.
Make sure that illuminated surfaces are more than 2 m away.
Do not operate the device in ambient temperatures above 40 °C.
Always ensure sucient ventilation at the operating location.
NOTICE!
Potential property damage due to unsuitable stands!
If the device is mounted on an unsuitable stand, there is a risk that the
stand will fall over and cause damage.
Only use stands whose maximum bearing capacity is at least as high as
the weight of the device. Always ensure that the stand is stable.
NOTICE!
Data transfer errors due to improper wiring!
If the DMX connections are wired incorrectly, this can cause errors
during the data transfer.
Do not connect the DMX input and output to audio devices, e.g. mixers
or ampliers.
Use special DMX cables for the wiring instead of normal microphone
cables.
Push the lock of the battery holder towards the centre of the housing and pull out
the battery holder like a drawer. Insert the batteries. The battery is correct if the posi‐
tive pole points to the housing base of the remote control. Slide the battery holder
back into the remote until it clicks into place.
When shipping, the battery is already installed in the remote and protected against
discharge by a transparent plastic lm. Remove the plastic lm before initial use.
NOTICE!
Risk of re due to incorrect polarity!
Incorrectly inserted batteries may cause res and destroy the device and
the batteries.
Observe the markings on the batteries and on the device.
Ensure that proper polarity is observed when inserting batteries.
NOTICE!
Possible damage due to leaking batteries!
Batteries can leak and cause permanent damage to the device.
Take the batteries out of the device if it is not going to be used for an
extended period of time.
Inserting the battery into the remote
control
Installation
All FX Bar
11
LED Eect

Bekijk gratis de handleiding van Stairville All FX Bar, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkStairville
ModelAll FX Bar
CategorieNiet gecategoriseerd
TaalNederlands
Grootte2667 MB