Stadler Form Erik handleiding
Handleiding
Je bekijkt pagina 11 van 100
the highest level to cool down the heating element. The current tem-
perature is then measured approx. every 30 minutes (the fan runs for 1
minute at the lowest level). The appliance switches on again if the room
temperature recorded drops below the set target temperature.
10. Protection against overheating: the appliance is equipped with over-
heating protection which switches off the appliance in the event of a
technical fault or improper use (the fan continues to run for some time at
the highest level to cool down the appliance). Should this occur, rectify
the fault or cease the improper use (e.g. 50 cm space around the ap-
pliance, do not cover the appliance, set the appliance up in an upright
position). Once the appliance has cooled down it can be put back into
service.
11. If the device is not used on a daily basis, switch it off by pressing the
On/Off button (8). If Erik was used with the aroma diffuser function and
fireplace effect, empty the water out of the appliance via the water out-
let (17). If the heating function was active, the fan remains switched on
at the highest level for 30 seconds to cool down the heating element.
Note: The device has a memory function and saves the last selected
setting for 24 h when you switch off the device and disconnect it from
the power supply.
Note: If you would like to change the fragrance, empty the water out of the
appliance via the water outlet (17). Clean the water tray (3) with a damp
cloth and a bit of dish detergent. Fill Erik once again and pour the drops into
the device following the instructions.
Cleaning
Prior to any maintenance, cleaning and after each use, switch off the appli-
ance (8) and unplug the mains cable (1) from the socket.
Attention: Never immerse the device in water (danger of short circuit).
Make sure that the air inlet (16) and air outlet (12) are cleaned regularly to
prevent the build-up of dust. Use a dry paintbrush or the soft brush attach-
ment for your vacuum cleaner to do this.
For hygienic reasons and to ensure proper operation, we recommend the
following cleaning intervals when Erik is used as an aroma diffuser and/or
as a fireplace effect:
• Daily: Fill the water tray (3) with fresh, cold tap water. If the appliance
is not used for several days, empty the water from the water tray (3) be-
forehand and if necessary, clean it with a bit of dish detergent and a clean
cloth. Pour the water out of the appliance via the water outlet (17). Fill
fresh water into the water tray (3), before putting the appliance back into
operation.
• Every 2 weeks: First remove the top part (2). Clean the inside of the wa-
ter tray (3) thoroughly with a bit of dish detergent, warm water and a soft,
clean cloth, sponge or brush. Use diluted descaling agent (mix according
to the manufacturer’s instructions) for lime deposits. Then rinse the water
tray (3) thoroughly with cold water and put the top part (2) back on.
• Descaling at least 1x per month. Remove the top part (2). If limescale
deposits form in the water tray (3) we recommend using Stadler Form
Cleaner & Descaler (www.stadlerform.com/accessories). Alternatively,
you can use a household decalcifier or vinegar. Fill a cup with 100 ml of tap
water mixed with descaling agent (mix according to the manufacturer’s
Bekijk gratis de handleiding van Stadler Form Erik, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Stadler Form |
| Model | Erik |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9084 MB |