Speed Queen FF7011WN handleiding
Handleiding
Je bekijkt pagina 8 van 13

Water Supply Requirements
Water supply faucets must fit standard 3/4 inch [19 mm] fe-
male garden hose couplings. DO NOT USE SLIP-ON OR
CLAMP-ON CONNECTIONS.
NOTE: Water supply faucets should be readily acces-
sible to permit turning them off when washer is not
being used.
Recommended cold water temperature is 50° to 75° Fahrenheit
[10° to 24° Celsius] . Recommended maximum hot water tem-
perature is 125° Fahrenheit [51° Celsius] . For models that
have the Sanitize with Oxi and the Pet Plus Flea cycles, the hot
water supply connection must provide a minimum of 120°
Fahrenheit [49° Celsius] . An adjustment to the water heater
may be necessary. Warm water is a mixture of hot and cold
water. Warm water temperature is dependent upon the water
temperature and the pressure of both the hot and cold water
supply lines.
WARNING
To prevent personal injury, avoid contact with inlet
water temperatures higher than 125° Fahrenheit [51°
Celsius] and hot surfaces.
W748
Maximum flow rate for all water temperatures is 2.5 gallons
per minute [9.46 liters per minute] ± 15%.
Water pressure must be a minimum of 20 to a maximum of
120 pounds per square inch [minimum of 138 to a maximum
of 827 kPa] static pressure measured at the faucet.
NOTE: Water pressure under 20 pounds per square
inch [138 kPa] will cause an extended fill time in the
washer and may not properly flush out the detergent
dispenser.
Turn on the water supply faucets and flush the lines for ap-
proximately two minutes to remove any foreign materials that
could clog the screens in the water mixing valve. This is espe-
cially important when installing your washer in a newly con-
structed or renovated building. Build-up may have occurred
during construction.
Connecting Hoses
1. Remove the two plain rubber washers and two filter screens
from the accessories bag.
2. Install them into each end of the fill hoses as shown in
Figure
7
. The screen must be facing outward.
3. Screw hose couplings with the filter screens onto the water
faucets until they are finger-tight.
4. Then, using a pliers, screw approximately 1/4 turn.
5. Screw hose couplings from other end of hoses onto the water
mixing valve until they are finger-tight. Refer to Figure
Fig-
ure 7
.
6. Then, using a pliers, screw approximately 1/4 turn.
IMPORTANT: DO NOT cross thread or overtighten
couplings. This will cause them to leak.
7. Turn water on and check for leaks.
8. If leaks are found, turn off the water, unscrew hoses and rein-
stall them until there are no leaks.
IMPORTANT: Turn off water supply whenever
there will be an extended period of non-use.
FLW2304N_SVG1
COLD
HOT
1
4
5
6
7
8
2
3
1. Filter Screen (Screen must be facing outward)
2. Fill Hose
3. Rubber Washer (Plain)
4. Cold Water Connection
5. Hot Water Connection
6. Install this end of hose to valve connections at rear of wash-
er.
7. Install this end of hose to water supply faucet.
8. Faucet
Figure 7
IMPORTANT:
Hoses and other rubber parts deteriorate after ex-
tended use. Hoses may develop cracks, blisters or
material wear from the temperature and constant
high pressure they are subjected to.
All hoses should be checked on a monthly basis for
any visible signs of deterioration. Any hose show-
ing the signs of deterioration listed above should be
replaced immediately. All hoses should be replaced
every five years.
Connect Drain Hose to Drain
Receptacle
Remove the drain hose from its shipping position on the rear
of the washer by unhooking the hose from the retainer clamp
and by removing the shipping tape.
Install the drain hose into the drain receptacle (standpipe, wall
or laundry tub) following the instructions below.
IMPORTANT: Drain receptacle must be capable of
handling a minimum of 1-1/4 inch [32 mm] outside di-
ameter drain hose.
Installation
© Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
8 Part No. 806987ENR3
Bekijk gratis de handleiding van Speed Queen FF7011WN, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
Merk | Speed Queen |
Model | FF7011WN |
Categorie | Wasmachine |
Taal | Nederlands |
Grootte | 1600 MB |