Speco Technologies O6MDP4 handleiding
Handleiding
Je bekijkt pagina 33 van 54
29
1. Enable the crowd density detection.
2. Set “Refresh Frequency”, “Density Alarm Threshold” and “Alarm Holding Time”.
Refresh Frequency: The refresh frequency of the detection result.
Density Alarm Threshold: Alarms will be triggered once the percentage of the crowd density in a specified area exceeds the
pre-defined threshold value.
3. Set alarm trigger options. The setup steps are the same as motion detection. Please refer to motion detection section for
details.
4. Set an alarm area for the crowd density detection. Click the “Area” tab as shown below.
Click “Draw Area” and drag the mouse to draw a rectangle area. Drag the border lines of the rectangle to modify its size and move
the rectangle to change its position. Click “Stop Draw” to stop drawing the area. Click “Clear” to clear the area.
Note: The image display may be different due to different installation modes. The following picture is for reference only.
5. Set the schedule of the crowd density detection. The setup steps of the schedule are the same as schedule recording setup
(See Schedule Recording).
Bekijk gratis de handleiding van Speco Technologies O6MDP4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Speco Technologies |
| Model | O6MDP4 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 13394 MB |
