Speco Technologies O4P3X handleiding
Handleiding
Je bekijkt pagina 32 van 60
28
Trigger SD Card Recording: If selected, the video will be recorded on an SD card when a target crosses the alarm line
Trigger Email: If “Trigger Email” and “Attach Picture” are checked (email address must be set first in the Email configuration
interface), the captured pictures and triggered event will be sent to those addresses.
Trigger FTP: If “Trigger FTP” is checked, the captured pictures will be sent to FTP server address. Please refer to the FTP
configuration section for more details.
4. Click “Save” to save the settings.
5. Set area and sensitivity of the line crossing alarm. Click the “Area and Sensitivity” tab to go to the interface as shown below.
Set the alarm line number and direction. Up to 4 lines can be added. Multiple lines cannot be added simultaneously.
Direction：A<->B, A->B and A<-B optional. This indicates the direction of the intruder who crosses over the alarm line that would
trigger the alarm.
A<->B: The alarm will be triggered when the intruder crosses over the alarm line from B to A or from A to B.
A->B: The alarm will be triggered when the intruder crosses over the alarm line from A to B.
A<-B: The alarm will be triggered when the intruder crosses over the alarm line from B to A.
Set the detection area by clicking the buttons of area ① and then click “Lock” to lock the area.
Note: The PTZ will not be controlled if you click “Lock” here. Click “Unlock” and then click the buttons of area ① to move the PTZ
camera. Clicking the “Unlock” button suspends object tracking until you click the “Lock” button.
Click the “Draw Area” button and then drag the mouse to draw a line in the image. Click the “Stop Draw” button to stop drawing.
Click the “Clear” button to delete the lines. Click the “Save” button to save the settings.
6. Set the schedule of the line crossing alarm. The setup steps of the schedule are the same as the schedule recording setup (See
Schedule Recording).
※Configuration of camera and surrounding area
1. Auto-focusing function should not be enabled for line crossing detection.
2. Avoid the scenes with many trees or the scenes with various light changes (like many flashing headlights). The ambient brightness
of the scenes shouldn’t be too low.
3. Cameras should be mounted at a height of 10ft or above.
4. Keep the mounting angle of the camera at about 45°.
5. The detected objects should not be less than 1% of the entire image and the largest sizes of the detected objects should not be
more than 1/8 of the entire image.
6. Make sure cameras can view objects for at least 2 seconds in the detected area for accurate detection.
7. Adequate light and clear scenery are crucial for line crossing detection.
4.5.3 Intrusion
Intrusion: Alarms will be triggered if the target intrudes into the defined areas.
Go to EventIntrusion as shown below.
Bekijk gratis de handleiding van Speco Technologies O4P3X, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Speco Technologies |
| Model | O4P3X |
| Categorie | Bewakingscamera |
| Taal | Nederlands |
| Grootte | 16834 MB |
