Speco Technologies O4P3X handleiding
Handleiding
Je bekijkt pagina 22 van 60
18
【Alarm Type】:Set the alarm enter type to be Normally Opened (N.O.) or Normally Closed (N.C.) according to the sensor type.
【Alarm In】:ON and OFF are optional.
【Alarm Trigger】: Call the preset/cruise/trace/random scanning/boundary scanning you need. When the first alarm input happens,
the camera will automatically switch to this preset/cruise/trace/ random scanning/boundary scanning to monitor.
【Alarm Over】:Call the preset/cruise/trace/random scanning/boundary scanning you need. When the alarm trigger is over, the
camera will automatically switch to this preset/cruise/trace/random scanning/boundary scanning to monitor.
【Alarm Out】: Select it ON. When alarm input occurs, the camera will output alarm information.
Note: If the dome is on the menu state on an alarm, any command is negative.
Home Position
This function is only supported by some models.
The setup steps are as follows:
1. Check “Run” and select the preset which should be set in advance.
2. Then select the wait time (range from 007s to 180s) and exit the menu.
When the stand-by time of the dome camera exceeds the wait time, the camera will automatically execute the command to monitor
the selected preset.
4.4 Alarm Setup
4.4.1 Motion Detection
Go to AlarmMotion Detection to set motion detection alarm.
Bekijk gratis de handleiding van Speco Technologies O4P3X, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Speco Technologies |
| Model | O4P3X |
| Categorie | Bewakingscamera |
| Taal | Nederlands |
| Grootte | 16834 MB |