Sonnenkonig Tronas 30 handleiding
Handleiding
Je bekijkt pagina 45 van 48
EN
45
IMPORTANT: To reduce the risk of damage to the vacuum, do not run motor with float in raised position.
NOTE: IF ACCIDENTALLY TIPPED OVER, THE VACUUM COULD CLOSED SUCTION. IF THIS OCCURS, PLACE VAC IN
UPRIGHT POSITION AND TURN SWITCH OFF. THIS WILL ALLOW THE FLOAT TO RETURN TO ITS NORMAL POSI-
TION, AND YOU WILL BE ABLE TO CONTINUE OPERATION.
NOTE: WET PICK-UP ACCESSORIES SHOULD BE WASHED PERIODICALLY, ESPECIALLY AFTER PICKING UP WET,
STICKY KITCHEN ACCIDENTS. THIS CAN BE ACCOMPLISHED WITH A WARM SOLUTION OF SOAP AND WATER.
FOAM filter
Float in raised position
EMPTY THE TANK
1. Remove the power head assembly of the wet/dry vacuum by pulling outward on the lid clips located on each side of
the vacuum. Lift off the power head assembly. Dump the tank contents into the proper waste disposal container.
2. Liquid waster may be emptied by removing the tank drain. To empty, turn unit off and remove plug from the wall
receptacle. Remove the drain cap and deposit the liquid waste conents in a suitable drain. After tank is emplty, re-
turn the drain cap to its original position. To continue use, plug the cord into the wall receptacle and turn the unit on.
1. Always disconnect the plug from the wall receptacle before removing the power head. Place power head in
an upside down position. Remove cartridge filter by sliding it up and off the filter cage.
2. Shake excess dust off cartridge filter with a rapid up and down movement.
3. This wet/dry vacuum is equipped with a float mechanism which will rise automatically to cut off the airflow
when the liquid in the tank reaches a predetermined level. When this happens, turn off vacuum, unplug the
power cord, and empty the dust tank. You will know that the float has shut the airflow off because the suc-
tion ceases and the motor noise becomes higher in pitch due to increased motor speed. The liquid capacity
may vary with the rate of pickup.
BLOWING OPERATION
The vacuum contains a blowing feature. It has the capability to blow sawdust and other debris. It can be used to blow
dust and debris out of garages or off patios and driveways. Follow the steps below to use the vacuum as a blower.
1. Locate blower port on the vacuum.
2. Insert one end of the hose into the blower port.
3. Turn vacuum “ON”.
WARNING: Always wear safety eyewear when using as a blower. To avoid injury to bystanders, keep them clear of
blowing debris.
CAUTION: Wear a dust mask if blowing creates dust which might be inhaled. To reduce the risk of hearing damage,
wear ear protectors when using the vacuum/blower for extended hours or when using it in a noisy area.
WARNING:
To reduce the risk of injury from accidental starting, unplug power cord before emptying
the dust tank.
Bekijk gratis de handleiding van Sonnenkonig Tronas 30, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sonnenkonig |
| Model | Tronas 30 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6999 MB |
