Sonnenkonig Tronas 30 handleiding
Handleiding
Je bekijkt pagina 44 van 48
EN
4444
DRY PICK-UP
1. The filter must always be in correct position to reduce the risk of leaks and possible damage to vacuum.
Make sure that the filter is completely covering the filter cage and that the clamp ring is as close to the lid as
possible. Make sure there are no gaps between the filter and the lid. (See illustration). It is very important to
assemble the filter to the cage without allowing any possible leaks or tears. Any leaks will allow the picked
up debris to be blown out of the blowing port and back into the surrounding environment.
2. When using your vacuum to pick up very fine dust, it will be necessary to empty the dust tank and clean or
replace the filter at more frequent intervals to maintain peak vacuum performance.
INSTALLING DISPOSABLE FILTER BAG
1. Slide the cardboard collar opening firmly onto the vacuum port deflector until it stops against the deflector wall.
2. Position the bag so that it is distributed around the inside of the tank.
3. Replace and secure the power head onto the tank.
INSTALLING THA CARTRIDGE FILTER
The cartridge filter can be used for wet or dry pick, installation is the same for both.
1. With the power head in an upside down position, slide the cartridge filter down over the lid cage, push the filter
seals against the power head.
2. Place filter retainer into the top of the cartridge filter, hold the power head with one hand, turn the handle on filter
retainer clockwise to tighten, locking the filter into place.
3. To remove the filter for cleaning, again hold the power head and turn the filter retainer counterclockwise to
loosen and remove, slide the cartridge filter off the lid cage.
4. To cleaning the cartridge filter, shake or brush off excess dirt or rinse (from the inside of the filter) with water, dry
completely (approximately 24 hours) and re-install.
WET PICK-UP
The cartridge filter must be positioned over the filter cage while vacuuming liquids. When picking up several tanks
full of liquid, the cartridge filter will become saturated and misting may appear in the exhaust air. At this time, you
should dry or replace the cartridge filter to eliminate the misting and possible dripping of liquid around the lid. After
completing a wet pick-up job, raise the hose to drain any excess liquid into the tank before shutting off. The interior
of tank should be periodically cleaned.
NOTE: A dry filter is necessary to pick up dry material. If you use the vacuum to pick up dust when the filter is
wet, the filter will clog quickly and be very difficult to clean. If the filter gets wet, replace it before continuing
to do dry pickups.
NOTE: If the filter has been used for wet pick-up, it must be cleaned and dried before using for dry pick-up.
Disposable filter bag
Bekijk gratis de handleiding van Sonnenkonig Tronas 30, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sonnenkonig |
| Model | Tronas 30 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6999 MB |
