Sommer ASB-6010A handleiding
Handleiding
Je bekijkt pagina 39 van 61
39
Control unit
Deleting a radio channel in the receiver
1. Press the radio button repeatedly to select the required radio channel.
Press and hold the Radio button for 25 seconds.
1 x 2 x 3 x 4 x
LED
CH 1
CH 2
CH 3
CH 4
⇒ The LED ashes after 15 seconds
⇒ After another 5 seconds, the ash sequence changes to blinking.
⇒ After another 5 seconds, the LED of the selected radio channel
remains steady
2. Release the Radio button.
⇒ The deletion procedure has been completed.
⇒ All programmed transmitters on the selected radio channel are
deleted from the radio receiver
Deleting all radio channels in the receiver
1. Press and hold the Radio button for 30 seconds.
⇒ The LED ashes after 15 seconds
⇒ After another 5 seconds, the ash sequence changes to blinking.
⇒ After another 5 seconds, the LED of the selected radio channel
remains steady
⇒ After another 5 seconds, all LEDs light up
2. Release the Radio button.
⇒ All LEDs are o after 5 seconds
⇒ All programmed transmitters are deleted from the receiver
⇒ Receiver is completely deleted; this also applies if the Memo
is plugged in
Programming a second transmitter by radio
(HFL)
Prerequisites for programming by radio
A handheld transmitter must already be programmed on the radio
receiver. The handheld transmitters used must be identical. This means,
for example, that a Pearl can only be programmed on a Pearl and a Pearl
Vibe on a Pearl Vibe.
The key assignment of handheld transmitter (A) that put the radio receiver
into teach-in mode by radio is used for the new handheld transmitter (B)
that is to be programmed.
The already-programmed transmitter and the new transmitter to be
programmed must be situated in the range of the radio receiver.
Example:
1. Button 1 on radio channel 1 and button 2 on radio channel 2 have
been programmed by handheld transmitter (A).
⇒ The newly-programmed transmitter (B) adopts the button
assignment of transmitter (A): Button 1 on radio channel 1, button 2
on radio channel 2.
Restriction
The following setting is not possible:
• The targeted teach-in of a selected handheld transmitter button on
a radio channel.
1
2
A
3
B
1. Press buttons 1 and 2 of a programmed handheld transmitter (A)
for 3 - 5 seconds until the LED on the handheld transmitter briey
lights up.
⇒ LEDs CH1 and CH2 blink
2. Release buttons 1 + 2 of the handheld transmitter (A).
⇒ If a radio command is not transmitted within another 30 seconds,
the radio receiver switches over to normal mode
3. Press any button, e.g. (3) on the new handheld transmitter (B) to be
programmed.
⇒ LEDs CH1 and CH2 go out
Bekijk gratis de handleiding van Sommer ASB-6010A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sommer |
| Model | ASB-6010A |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7965 MB |
