Solid State Logic SSL 18 handleiding
Handleiding
Je bekijkt pagina 13 van 54
8. LED METERING
8x5 LED columns show the input or output level of analogue inputs 1-8. If set to input, It is good practice to aim for the '-20' mark (the
third green meter point) when recording. Occasionally going into '-10' is fine. If your signal is hitting '0' (top red LED), that means it is
clipping, so you'll need to lower the GAIN control or output from your instrument. Scale markings are in dBFS.
Dedicated output meters for Left and Right (outputs 1-2) are located on the right-hand side.
Beneath the output meters, the LED Panel also displays information regarding the current operating sample rate, with 44.1 & 48 kHz
rates followed by a p13-x2 that will highlight in conjunction with 44.1 to denote 88.2kHz & 48 & 2x for 96kHz, and a 4x for 172.4 & 192kHz.
There is also a clock source information with DIGI for external clocking via ADAT or S/PDIF & the USB light for Internal clocking, and
then below there is IN & OUT to display if the meters are showing input or Output signal, controllable via the SSL 18 360° Mixer page.
Monitor Controls
9. MONITOR LEVEL (Blue Control)
The monitor level directly affects the level sent out of OUTPUTS 1 (Left) and 2 (Right) to your monitors. Turn the knob to make the
volume louder. Please note the monitor level goes to 11 because it's one louder...
Note that if ALT SPK mode is engaged, Monitors connected to OUTPUTS 3 & 4 will also be controlled via the Monitor Level Control.
10. CUT
This button mutes the Monitor Output Signal.
11. ALT
Switches the Monitor Bus to an alternative set of monitor speakers that you have connected to OUTPUTS 3&4. To do this ALT SPK
ENABLE must be active in SSL 360°.
11. TALK
This button engages the on-board Talkback mic input. The signal can be routed to any combination of Headphones A, Headphones B
and Line 3-4 (providing Line 3-4 is not being used as ALT monitors) in the SSL 18 Mixer page of SSL 360°.
Please Note: Interface buttons annotated as 10, 11 & 12 in the description are also user-assignable using SSL 360° but they come
defaulted to the silkscreened functions (CUT, ALT, TALK) on the front panel. To re-assign, go to SSL 360° and right-click on these
buttons in the GUI - a list of assignable functions will appear.
12. HEADPHONE OUTPUTS
HP A & B allow for two sets of headphones to be connected, both of which can be configured to allow independent mixes for artist and
engineer. By default, both will follow the monitor control mix (so you can listen to music/your DAW straight-away). To make them
independent mixes (fed from HP A and HP B busses), disable the "Follow Mix 1-2" button in SSL 360°.
1/27/25, 9:53 AM
SSL 18 User Guide – SSL Support
https://support.solidstatelogic.com/hc/en-gb/articles/23411101112477-SSL-18-User-Guide
13/54
Bekijk gratis de handleiding van Solid State Logic SSL 18, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Solid State Logic |
| Model | SSL 18 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8982 MB |