Handleiding
Je bekijkt pagina 15 van 52
15español english français portuguese italiano deutsch
MAINTENANCE
1. Always remove the plug from the socket-outlet and allow the radiator to cool down before clean
the heater.
2. Wipe radiator with a soft damp (not wet) cloth. WARNING:
Do not immerse the heater in water.
Do not use any cleaning chemicals such as detergents and abrasives.
Do not allow the interior to get wet as this
could create a hazard.
3. To store away the heater, wind the cable round bobbin and store the heater in a clean dry place.
4. In case of malfunction or doubt, do not try to repair the radiator yourself, it may result in a fire
Hazard or electric shock.
1. Before using the heater, make sure that it is on it is placed on a flat and stable surface, damage
may occure on an incline or declined surface.
2. Set all the controls to OFF position and insert the plug into a socket-outlet with well grounded.
make sure that plug filts firmly
3. Rotate the thermostat knob clockwise to MAX
position and switch the heater to low, medium and
high
4. When your room reaches the desired temperature, now slowly rotate the thermostat knob
counter clockwise until the pilot light goes out. The thermostat can now be left at this setting. As
soon as the room temperature has dropped below the set temperature, the unit will switch it self
on automatically until the set temperature has been reached again. In this way the room
temperature remains constant with the most economical use of electricity.
5. If you want to change the room temperature setting, rotate the thermostat knob clockwise to
raise the temperature, or counter clockwise to lower it.
6. This heater includes an overheat protection system that shuts off the heater when parts of the
heater are getting excessively hot.
7. To completely shut the heater off, turn all the controls to OFF, and remove plug from the socket-
outlet.
Tip-over protection
This heater is protected with a safety switch that turns off the appliance automatically when the
heater falls over, or is at an
excessive angle from the horizontal. This helps prevent accidents,
and the heater will resume operation when it is put back upright.
Overheat protection
This heater is protected with overheat protection that switches off the appliance automatically in
case of severe overheating. In this case, unplug the appliance, wait about 30 minutes for it to
cool and remove any possible cause of overheating, eg. something covering the heater. Check
for damage to the appliance, the cord and the plug. If there is no damage, plug the unit back in
and switch it on as described above. If the heater still does not turn on, please contact Customer
Service for assistance.
INSTRUCTIONS FOR USE
Bekijk gratis de handleiding van Sogo SS-18460, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sogo |
| Model | SS-18460 |
| Categorie | Heater |
| Taal | Nederlands |
| Grootte | 5080 MB |
