Handleiding
Je bekijkt pagina 14 van 52

ASSEMBLY INSTRUCTIONS
The heater is packaged with the feet unattached. You must attach them before operating the heater.
WARNING: Do not operate without feet attached. Do operate the heater only in upright
position (feet on the bottom, controls on the top), any other position could create a
hazardous situation.
14 español english français portuguese italiano deutsch
TECHNICAL SPECIFICATION
MODEL NO.: SS-18455
VOLTAGE / FREQUENCY: 220 - 240V~ 50Hz
POWER: 1.500 W
MODEL NO.: SS-18460
VOLTAGE / FREQUENCY: 220 - 240V~ 50Hz
POWER: 2000W
MODEL NO.: SS-18465
VOLTAGE / FREQUENCY: 220 - 240V~ 50Hz
POWER: 2500W
1. Place the radiator body upside-down on a
scratch-free location, make sure it is stable
and will
not fall.
2. Screw off the wing nuts from the U-shaped
bolt provided, attach the U-shaped bolt to the
U
facing flange between first and second fins.
(near the front cover
).
3. T
o attach the castor mounting plate to the radiator body, you should insert the threaded ends of
the U bolt in the holes on the castor mounting plate.
4. Screw the wing nuts back to the U bolt and fasten the wing nut properly.
Note: do not over tighten, which may cause the damage to radiator flange.
5. Repeat 2, 3 and 4 on the rear of radiator for mounting of the rear castors.
Note: the rear castors must be mounted between the last 2 fins.
Remark: Only for model SS-18455, fit the front wheels assembly at the bottom of front panel by
two screws(see Fig 5), the other wheels assembly same as point 2, 3 and 4.
1. Carry handle
2. Power switch
3. Thermostat knob
4. Cord storage
6. Castor
PARTS DESCRIPTION
WARNING:In order to avoid
overheating, do not cover the heater
Bekijk gratis de handleiding van Sogo SS-18460, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
Merk | Sogo |
Model | SS-18460 |
Categorie | Heater |
Taal | Nederlands |
Grootte | 5080 MB |