Silvercrest SWB 145 A2 handleiding
Handleiding
Je bekijkt pagina 11 van 14
11GB/IE/NI
o Use + [6] and –[8] to adjust the
temperature. The set temperature flashes
on the display[5]. The display[5] lights up
continuously once the selected temperature is
reached.
o The following temperatures are recommended
depending on the type of hair:
Type of hair
Recommended
temperature
Bleached/lightened hair 100to140 °C
Fine and colour‑treated hair 100to140 °C
Normal natural hair 140to160 °C
Strong and resistant hair 160to200 °C
Styling the hair
NOTES:
Do not touch the scalp with the triple‑barrel
waver[2] and the hot barrels[].
The hair must be clean, dry and free from
styling products. This excludes special
products that support the styling.
Comb the hair thoroughly before styling.
Use the product in a well‑ventilated room.
Wait until the hair has cooled down before
brushing or combing it. Otherwise the result
might not be satisfactory.
1. Put the styling glove [] onto the hand used
for styling the hair.
2. Section off a strand of hair (approx. 4 cm
wide).
3. Press the finger rest [3] to open the
triple‑barrel waver [2].
4. Put the strand of hair on the hot barrels [].
5. Release the finger rest [3] slowly to release
the triple‑barrel waver [2].
6. Hold the strand of hair in the product for
approx. 5to8 seconds (depending on the
hair type).
7. Press the finger rest [3] to open the
triple‑barrel waver [2]. Carefully remove the
hair.
If necessary, repeat the above steps until the
result is satisfactory.
8. Switch off the product once the styling is
completed.
9. Remove the mains plug[9] from the socket‑
outlet. Allow the product to cool down
completely in a well‑ventilated location and
out of the reach of children.
10. Remove the styling glove[] from the hand.
Automatic switch‑off function
NOTES:
The product is fitted with an automatic
switch‑off function. After approx. 30 minutes
the product switches off automatically. The
display[5] goes out.
Switch the product back on to continue using
the product.
The automatic switch‑off is a safety function
only.
The automatic switch‑off function is not
intended as a replacement for switching the
product off properly.
Troubleshooting
Problem Possible cause Action
The product is not working.
The mains plug[9] is not
connected to a socket‑outlet.
Connect the mains plug[9] to a
socket‑outlet.
The socket‑outlet is defective. Try a different socket‑outlet.
Bekijk gratis de handleiding van Silvercrest SWB 145 A2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Silvercrest |
| Model | SWB 145 A2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1039 MB |
