Silvercrest SWB 145 A2 handleiding
Handleiding
Je bekijkt pagina 10 van 14
10 GB/IE/NI
People fitted with a heart
pacemaker should consult their
doctor about the possible risks
of using this product before
taking it into use.
Never place the product close
to sources of heat. Do not let
the mains cord touch the hot
surface.
Do not use or store the product
in or expose it to a humid
environment.
Always disconnect the product
from the mains when it is
unattended or after use.
m
WARNING! Risk of burns!
The styling glove does not
provide thermal and physical
protection.
Do not touch hot objects, fire,
sharp points or sharp edges
when wearing the styling glove.
Injuries could be caused by
improper use.
Before first use
m
WARNING! Be careful with the weight
of the product. Before switching on, check
whether you can carry the weight of the
product with one hand.
NOTE: The product may give off some odour
during first use. These are production or
transport residue that will quickly subside.
o Remove the packaging. Check if all parts are
complete.
Operation
Preparing the product
NOTES:
Before you switch on the product, make sure
that the stand rack[4] does not touch the
product.
Place the product in the correct position on a
heat‑resistant, flat surface.
1. Fold out the stand rack [4] (Fig. B). Make
sure the following parts do not touch the
supporting surface:
– Cool tip[1]
– Triple‑barrel waver[2]
– Hot barrels[]
2. Connect the mains plug[9] to a suitable
socket‑outlet.
Switching on/off
m
WARNING! Risk of burns!
The product becomes very hot during use. Do
not touch the triple‑barrel waver[2] and the
hot barrels []:
– when the product is switched on, or
– right after switch off.
Always hold the product by its handle[].
Do not touch the triple‑barrel waver[2]
and the hot barrels[] when wearing the
styling glove[]. Injuries could be caused by
improper use.
o Switching on the product: Press and hold
[7] for approx. 2 seconds. 100 °C flashes
on the display [5]. The product heats up.
o Switching off the product: Press and hold
[7] for approx.2 seconds. The display[5]
goes out.
Adjusting the temperature
NOTES:
The temperature can be set between 100 °C
and 200 °C in 10 °C increments.
Start at the lowest recommended temperature.
If required, adjust the temperature in small
steps to reach the optimum temperature
setting.
Bekijk gratis de handleiding van Silvercrest SWB 145 A2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Silvercrest |
| Model | SWB 145 A2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1039 MB |
