Silvercrest SKPE 3 A1 handleiding
Handleiding
Je bekijkt pagina 17 van 66
17GB/IE/NI
Operation
Do not operate the product for more than 5 minutes. Allow the
product to cool down before operating it again.
Choose a rubber collar [9] which matches the handle diameter
of the brush to be cleaned. The brush handle should fit tightly
into the rubber collar so it does not accidentally fall out.
Slide the brush handle into the round opening of the rubber
collar [9].
Slide the other end of the rubber collar [9] onto the drive
shaft [1]. All parts are aligned in a straight line. Misalignment
may affect the performance of the product (fig. E).
Place the brush into the bowl [7], submerging the bristles. Do
not submerge the brush beyond the bristles (fig. F).
Gently sweep the bristles against the bottom of the bowl [7] for
5 seconds.
Move the brush up and down in the liquid for 5 seconds.
Submerge the bristles (fig. G).
Switch product on: Press and slide the I/0 switch [3] to the
I position. The drive shaft [1], and therefore the attached brush,
starts to spin. Allow to spin for 10 seconds. Move the brush up
and down in the liquid (fig. G).
After 10 seconds lift the bristles above the liquid. Allow to
spin for a further 10 seconds, to dry the bristles (fig. H). If the
bristles are still wet after 10 seconds, spin for an additional
10 seconds.
Switch product off: Slide the I/0 switch [3] to the 0 position.
Bekijk gratis de handleiding van Silvercrest SKPE 3 A1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Silvercrest |
| Model | SKPE 3 A1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3449 MB |
