Silvercrest SHBS 3.7 B2 handleiding
Handleiding
Je bekijkt pagina 10 van 90
8
GB
• The possible cutting length is indicated
on each of the three comb attachments:
- Comb attachment3: 1–11 mm
- Comb attachment2: 12–22 mm
- Comb attachment1: 23–33 mm
6.3 Cutting hair
NOTES:
• The hair to be dressed must be dry.
• The cutting length may deviate depend-
ing on the cutting angle.
• Place a sheet or cape around throat and
neck to prevent cut-off hair from dropping
into the collar.
• Comb the hair well.
• First, start with a comb attachment1
with a longer cutting length and then, in
the course of the cutting process, use
shorter cutting lengths step by step.
• Start by cutting the hair in the neck or
on the sides and cut towards the centre
of the head. Then, cut the front section
of hair towards the centre of the head.
• Figure F:
hold the hair and beard trim-
mer
5
so that the upper end of the comb at-
tachment
1,2,3 lies as flat as possible
against your head. Move the device
evenly through the hair.
• If possible, cut against direction of hair
growth.
• In order to catch all the hair, move the
hair and beard trimmer5 several times
through each section of hair.
• Comb the hair repeatedly and well.
• In order to achieve a straight cutting line
for cutting lengths over 12 mm, the hair
and beard trimmer5 should be passed
through the hair several times from dif-
ferent directions.
6.4 Trimming a beard
NOTE: please keep in mind that the corre-
sponding
cutting lengths are only achieved, if
the hair and beard trimmer5 is held at a
right angle to the skin surface.
• Comb the beard in the direction that it
grows.
• Cut the beard downwards from ear to
chin. First trim one side, then the other.
• Comb attachment
3
Figure C: adjust the cutting length with
the dial
7 according to the desired hair
length. Now, shorten your beard step-
by-step.
• Only use the trimmer attachment
4 to
cut the beard very short or to cut a
moustache and contours.
• To trim your moustache, first comb it
straight downwards. Start at the centre
above the mouth and trim first one side,
then the other.
7. Cleaning and care
WARNING! Risk of injury!
~ Always switch off the hair and beard
trimmer5 before cleaning.
WARNING! Risk of material dam-
age!
~ Do not use any astringent or abrasive
cleaning agents.
~
If necessary, disconnect the USB charger
cable
13
from the device.
NOTE: clean and oil the device after every
use.
Hair and beard trimmer
• Wipe the housing of the hair and beard
trimmer with a damp cloth.
__452972_2310_B7.book Seite 8 Dienstag, 12. März 2024 10:36 10
Bekijk gratis de handleiding van Silvercrest SHBS 3.7 B2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Silvercrest |
| Model | SHBS 3.7 B2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8911 MB |
