Silvercrest SABD 3.7 LI D4 handleiding
Handleiding
Je bekijkt pagina 19 van 74
SABD 3.7 LI D4■ 16
│
GB
│
IE
Cleaning and Care
DANGER! RISK OF ELECTRIC SHOCK!
► Do not clean the appliance while charging it.
Always disconnect the battery charger w
from the mains power socket before cleaning
the appliance!
NEVER immerse the appliance in water or
any other liquid!
WARNING! RISK OF INJURY!
► Ensure that the appliance is not accidentally
switched on without the dirt container 0
attached or while cleaning the rotary
brushz. Risk of injury!
ATTENTION! PROPERTY DAMAGE!
► Do not use abrasive or aggressive cleaning
materials. These may damage the surfaces.
Housing
■ Wipe off the appliance housing with a damp
cloth. If required, use a mild washing-up liquid
on the cloth.
■ Ensure that the appliance is completely dry
before reconnecting it with the battery
chargerw.
Dirt container
To ensure that the performance of the cordless
sweeper does not deteriorate, empty the dirt
container 0 after every use.
■ Press the push-in connection q on the dirt
container 0 and pull it off.
■ Empty the dirt container 0 and push it back
onto the appliance so that it sits firmly on the
appliance and clicks into place on the release
knob q.
Rotary brush
If the rotary brush z can no longer be turned
because coarse dirt or threads have accumulated,
proceed as follows:
Remove the rotary brush z. Refer to figures E and
F on the fold-out page of these operation
instructions for further guidance:
1) Turn the cordless sweeper over and hold it so
that the rotary brush z is facing towards you.
2) Pull on the hook of the catch t and remove
the side cover r.
3) Pull the rotary brush z upwards out of the
housing and then out to the side.
4) Remove any dirt (on both sides of the brush
bristles) and clean the rotary brush z.
To do this, take a damp cloth and wipe the
individual bristle bundles from the inside to the
outside.
NOTE
► Remove hair and threads from the brush by
cutting them with the knife e and pulling
them out of the rotary brush z.
Reinsert the rotary brush z:
1) Push the round end of the rotary brush z
onto the drive shaft u.
2) Push the square end of the rotary brush z
into the housing so that the rotary brush z
sits straight in the housing again.
3) Replace the cover r in the housing.
Make sure that the catch t engages.
Bekijk gratis de handleiding van Silvercrest SABD 3.7 LI D4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Silvercrest |
| Model | SABD 3.7 LI D4 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7089 MB |
