Showtec Xpression 2000B handleiding
Handleiding
Je bekijkt pagina 21 van 52
5.3.4. DMX Linking
To connect multiple devices on one DMX data link, follow the steps below:
01) Use a 3-pin DMX cable to connect the DMX OUT connector of the lighting controller to the DMX IN01)
connector of the 1
st
device.
02)
Connect the DMX OUT connector of the 1
st
device to the DMX IN connector of the 2
nd
device with a 3-pin
02)
DMX cable.
03)
Repeat step 2 to connect all devices in a daisy-chain.
03)
04)
Connect a DMX terminator (120 Ω resistor) to the DMX OUT connector of the last device on the data link.
04)
Figure 12
5.3.5. DMX Addressing
In a setup with multiple devices, make sure that you set the DMX starting address of each device correctly. The
Xpression 2000B - Beam has 2 personalities: 14 channels and 18 channels.
If you want to connect multiple devices on one data link and use them in 18-channel mode, for example,
follow the steps below:
01) Set the starting address of the 1
st
device on the data link to 1 (001).01)
02) Set the starting address of the 2
nd
device on the data link to 19 (019), as 1 + 18 = 19.02)
03) Set the starting address of the 3
rd
device on the data link to 37 (037), as 19 + 18 = 37.03)
04) Continue assigning the starting addresses of the remaining devices by adding each time 18 to the previous04)
number.
Make sure that you do not have any overlapping channels in order to control each Xpression 2000B - Beam
correctly. If two or more devices are addressed similarly, they will work similarly.
20
c
Product code: 47020
Xpression 2000B - Beam
Bekijk gratis de handleiding van Showtec Xpression 2000B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Showtec |
| Model | Xpression 2000B |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 6551 MB |
