Showtec Sonus Bar 4B handleiding
Handleiding
Je bekijkt pagina 16 van 44
5.2.3. Master/Slave Setup
The Sonus Bar 4B supports master/slave control mode. To connect multiple devices in a master/slave setup,
follow the steps below:
01) Connect the DMX OUT connector of the 1
st
device to the DMX IN connector of the 2
nd
device with a 3-pin01)
DMX cable.
02) Repeat step 1 to connect all devices in a daisy-chain.02)
03) Connect a DMX terminator (120 Ω resistor) to the DMX OUT connector of the last device on the data link.03)
04)
Set the 1
st
device on the data link as a master device. Refer to Slave Mode (see 6.7.8. Slave Mode on page
04)
26) for more information.
05)
Select a slave setting for the other devices on the data link. Refer to Slave Mode (see 6.7.8. Slave Mode on
05)
page 26) for more information.
Figure 8
5.2.4. DMX Linking
To connect multiple devices on one DMX data link, follow the steps below:
01) Use a 3-pin DMX cable to connect the DMX OUT connector of the lighting controller to the DMX IN01)
connector of the 1
st
device.
02) Connect the DMX OUT connector of the 1
st
device to the DMX IN connector of the 2
nd
device with a 3-pin02)
DMX cable.
03) Repeat step 2 to connect all devices in a daisy-chain.03)
04) Connect a DMX terminator (120 Ω resistor) to the DMX OUT connector of the last device on the data link.04)
Figure 9
15
c
Product code: 41275
Sonus Bar 4B
Bekijk gratis de handleiding van Showtec Sonus Bar 4B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Showtec |
| Model | Sonus Bar 4B |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 4374 MB |
