Showtec Single Strip for Octostrip FLEX – 0,5M handleiding

Verlichting

Showtec

20 pagina's

PDF beschikbaar

Handleiding

4.4. Rigging

CAUTION

Restrict the access under the work area during rigging/derigging.

You can position the LED strip on a flat surface or mount it to a rigging structure or to a flat surface in any

orientation.

You need a mounting bracket to mount the LED strip. The LED strip is delivered without a mounting bracket. You

can purchase a mounting bracket separately. Contact your Highlite International dealer for more information.

Make sure that all loads are within the pre-determined limits of the supporting structure.

4.4.1.

Installation of the Mounting Bracket

To install the mounting bracket (product code: 42234):

01)

Insert the 2 screws delivered with the mounting bracket through the mounting opening (03).

01)

02)

Slide the screws in the sliding profile (02) at the same distance as the openings on the mounting bracket.

02)

03)

Position the mounting bracket on top of the LED strip, so that the screws fit into the openings on the

03)

mounting bracket.

04) Tighten the 2 hex nuts delivered with the mounting bracket on the screws. Make sure that the screws04)

cannot slide freely along the sliding profile (02).

Figure 4

Note:

You can position the mounting bracket at any place along the sliding profile (02).

Product code: 42242

Single Strip for Octostrip FLEX – 0,5M

Bekijk gratis de handleiding van Showtec Single Strip for Octostrip FLEX – 0,5M, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.