Showtec Performer Fresnel 2200 DDT handleiding

40 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 30 van 40
6.6.6.7. PWM
In this submenu you can select the PWM (pulse-width modulation) rate of the device.
01) Press the UP/DOWN buttons to select one of the 6 options:01)
600 Hz
1200 Hz
2400 Hz
4000 Hz
6000 Hz
25000 Hz
02) Press the ENTER button to confirm the setting.02)
Note:
When you select 25000 Hz, make sure that you select OFF in the Curve submenu (see 6.6.6.1. Curve). 25000
Hz cannot dim according to CURVE1, CURVE2 or CURVE3 and does not give a smooth dimming output.
6.6.7. Calibration
In this menu you can use 2 slots to manually set up a zoom limit (0–255).
01) Press the ENTER button to open the submenu. Use the password (see 6.4.1. Password Input on page 22).01)
02) Press the ENTER button again to open the submenu.02)
03) Press the UP/DOWN buttons to select one of the 2 slots:03)
04) Press the UP/DOWN buttons to select a value.04)
05) Press the ENTER button to confirm the setting.05)
6.6.8.
Info
In this menu you can view information about the device.
01)
Press the UP/DOWN buttons to select one of the 2 options:
01)
VERSION: Shows the current firmware version
RDM
02) Press the ENTER button to view the information.02)
03) If you select RDM, press the UP/DOWN buttons to select one of the 2 options:03)
UID: Shows the unique identification number of the device that the RDM controller
receives. Access UID through the RDM submenu
LABEL: Shows the name of the device that the RDM controller receives. Access LABEL
through the RDM submenu
04) Press the ENTER button to view the information.04)
29
c
Product code: 33045
Performer Fresnel 2200 DDT

Bekijk gratis de handleiding van Showtec Performer Fresnel 2200 DDT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkShowtec
ModelPerformer Fresnel 2200 DDT
CategorieVerlichting
TaalNederlands
Grootte4487 MB