Showtec Melodist Mobile handleiding

28 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 17 van 28
5.4.3. DMX Linking
To connect multiple devices on one DMX data link, follow the steps below:
01) Use a 5-pin DMX cable to connect the DMX OUT connector of the lighting controller to the DMX IN01)
connector of the 1
st
device.
02)
Connect the DMX OUT connector of the 1
st
device to the DMX IN connector of the 2
nd
device with a 5-pin
02)
DMX cable.
03)
Repeat step 2 to connect all devices in a daisy-chain.
03)
04)
Connect a DMX terminator (120 Ω resistor) to the DMX OUT connector of the last device on the data link.
04)
Figure 11
5.4.4. DMX Addressing
In a setup with multiple devices, make sure that you set the DMX starting address of each device correctly. The
Melodist Mobile has 2 personalities: Player Mode (5 channels) and Trigger Mode (11 channels).
If you want to connect multiple devices on one data link and use them in 11-channel mode, for example,
follow the steps below:
01) Set the starting address of the 1
st
device on the data link to 1 (001).01)
02)
Set the starting address of the 2
nd
device on the data link to 12 (012), as 1 + 11 = 12.
02)
03) Set the starting address of the 3
rd
device on the data link to 23 (023), as 12 + 11 = 23.03)
04) Continue assigning the starting addresses of the remaining devices by adding 11 each time to the previous04)
number.
When addressing multiple devices on one data link, make sure that there are no overlapping channels. You
cannot control devices individually if they have overlapping channels.
16
c
Product code: 50422
Melodist Mobile

Bekijk gratis de handleiding van Showtec Melodist Mobile, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkShowtec
ModelMelodist Mobile
CategorieNiet gecategoriseerd
TaalNederlands
Grootte2846 MB