Handleiding
Je bekijkt pagina 41 van 75
English−41
Setting the Remote Control ID Function
The remote control can be used to control up to 25 individual MultiSync monitors using what is called the REMOTE CONTROL
ID mode. The REMOTE CONTROL ID mode works in conjunction with the Monitor ID, allowing control of up to 25 individual
MultiSync monitors. For example, if there are many monitors being used in the same area, a remote control in normal mode
would send signals to every monitor at the same time (see Figure 1). Using the remote in REMOTE CONTROL ID mode will
only operate one specic monitor within the group (see Figure 2).
To Set Remote Control ID (Entering REMOTE CONTROL ID mode)
While holding down the REMOTE ID SET button on the remote control, use the
KEYPAD to input the Monitor ID (1-25) of the monitor to be controlled via remote.
The remote control can then be used to operate the monitor having that specic
Monitor ID number.
When 0 is selected or when the remote control is in normal mode, all monitors will
be operated.
To Reset REMOTE CONTROL ID mode
Normal Mode - To return to Normal Mode press the REMOTE ID CLEAR button
and hold down for 5 seconds.
TIP: • In order for this feature to work properly, the monitor must be assigned a
Monitor ID number. The Monitor ID number can be assigned under the
Setup menu in the OSD. See page 66.
• Point the remote control toward the remote sensor of the desired monitor
and press the REMOTE ID SET button. The MONITOR ID number is
shown on the screen when your remote control is in ID mode.
Use the Remote Control to Control all Monitors in Range
1. On the remote control, press and hold down the REMOTE ID SET button while
using the keypad to input the REMOTE CONTROL ID number “0”.
2. All monitors within range of the remote control will now respond to keypad
press.
TIP: • When the REMOTE ID is set to “0”, pressing REMOTE ID SET will make
all monitors, within range of the remote signal, show their Monitor ID on screen.
This way you can easily see what the Monitor ID is if you want to control a single monitor, as described below.
Use the remote control to operate a monitor that has a specic MONITOR ID number assigned to it
1. Set the [Monitor ID] number for the monitor (see page 66). The [Monitor ID] number can range from 1-25.
This [Monitor ID] number allows the remote control to operate this specic monitor without affecting other monitors.
2. On the remote control, press and hold down the REMOTE ID SET button while using the keypad to input the REMOTE
CONTROL ID number (1-25). The REMOTE ID NUMBER should match the MONITOR ID number of the monitor to be
controlled.
3. Point the remote control toward the remote sensor of the desired monitor and press the REMOTE ID SET button.
The MONITOR ID number is shown in red on the monitor.
If the REMOTE CONTROL ID is “0”, then all monitors in range will show their particular MONITOR ID number in red.
If the MONITOR ID number is shown in white on the monitor, the MONITOR ID number and the REMOTE CONTROL ID are
not the same.
Monitor ID:1 Monitor ID:2 Monitor ID:3
Monitor ID:1 Monitor ID:2 Monitor ID:3
Remote does
not work
Remote does
not work
Remote works
Remote works Remote works Remote works
Figure 1
Remote in Normal
mode or the
REMOTE ID is
set to 0
Figure 2
Remote set up to
use REMOTE ID:3
You need a remote control
for this function.
Bekijk gratis de handleiding van Sharp MultiSync ME862, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sharp |
| Model | MultiSync ME862 |
| Categorie | Monitor |
| Taal | Nederlands |
| Grootte | 7928 MB |
