Handleiding
Je bekijkt pagina 35 van 46
English−35
Troubleshooting
nScreen Image and Video Signal Issues
No picture
• Make sure the signal cable is fully connected to the monitor and the computer.
• Make sure the computer’s display card is fully seated in its slot.
• Make sure there is no DisplayPort converter adapter connected. The monitor does not support DisplayPort converter
adapter.
• Make sure both the computer and monitor are powered on.
• The monitor may be in power saving mode. The monitor automatically goes into standby at the preset time period after the
video signal is lost.
• If the current input terminal connection has no active input signal, touch the INPUT/SELECT key to switch inputs.
• If the OSD menu setting [VIDEO DETECT] is set to [NONE], change the setting to [FIRST].
• Make sure that a supported resolution has been selected on the display card or system being used. If in doubt, please refer
to the OPERATION MANUAL of the display controller or system to change the resolution.
• Check the monitor and your display card with respect to compatibility and recommended signal timings.
• Check the signal cable connector for bent or pushed-in pins.
• Make sure the connected device outputs a signal to the monitor.
• If the front LED is dark blue, check the status of the [OFF MODE SETTING] (see page 23) or [HUMAN SENSING]
(see page 24).
• The monitor will automatically turn off by the “POWER SAVE TIMER” function when the “POWER SAVE TIMER” setting is
“ON” and continues in power save mode for 2 hours. Please touch the power key.
Image Persistence
• Do not display a still picture for a long period, as this could cause a residual image (see page 10).
Selected resolution is not displayed properly
• If the resolution you set is over or under a range, “OUT OF RANGE” window will appear then warn you. Please set
supported resolution at the connected computer.
The image is unstable, unfocused or swimming is apparent
• Use the OSD Image Adjust controls to focus and adjust the diaplay by increaseing or decreasing the [Fine] adjustment.
When the display mode is changed, the OSD Image Adjustsettings may need to be resdjusted.
• Make sure the signal cable is fully connected to the monitor and the computer.
• Check the monitor and your display card with respect to compatibility and recommended signal timings.
• If your text is garbled, change the video mode to non-interlace and use the 60Hz refresh rate.
• Disconnect the DisplayPort cable and touch the MENU key. Select DP LONG CABLE then adjust the OSD value using the
"(LEFT)" key or "(RIGHT)" key.
Bekijk gratis de handleiding van Sharp MultiSync EA241F, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sharp |
| Model | MultiSync EA241F |
| Categorie | Monitor |
| Taal | Nederlands |
| Grootte | 4378 MB |
