Handleiding
Je bekijkt pagina 33 van 139
EN - 14
10- Timer selection
11- Boost
12- On/Off
Use the induction cooking zones with
suitable cookware.
After mains voltage is applied, all displays
are illuminated briefly. After this, the hob is
in stand-by mode and ready for operation.
The hob is controlled by pressing the
appropriate electronic button. Each button
pressed is followed by a buzzer sound.
Switching the Appliance On
Switch the hob on by pressing the ON/
OFF button
. All heater displays show
a static “0” and the bottom right dots blink.
(If a cooking-zone is not selected within 20
seconds, the hob will automatically switch
off).
Switching the Appliance Off
Switch the hob off at any time by pressing
.
The ON/OFF button always has priority
over the switch-off function.
Switching the Cooking Zones On
Press the zone selection button that
corresponds to the zone you wish to use.
A static dot will be shown on the selected
zone display and the blinking dots on all
other zone displays will no longer illuminate.
Select the temperature setting by using the
increase heat setting button
or decrease
heat setting button . The element is now
ready to use. For faster boil times, select
the desired cooking level, then touch the 'P'
button to activate the Boost function.
Switching the Cooking Zones Off
Select the element you want to switch off by
pressing the heater selection button. Using
the
button, turn the temperature down
to “0”. (Pressing the and buttons
simultaneously also turns the temperature
to “0”).
If the cooking zone is hot, “H” will be
displayed instead of “0”.
Switching all Cooking Zones Off
To switch all the cooking zones off at once,
press the
button
In the stand-by mode, a “H” will appear on
all cooking zones which are hot.
4.2
PoWer ManaGeMent funCtion
Thanks to the power management function,
you can set the maximum power of the hob
if needed and the power limit will never be
exceeded.
How it works
If total the power exceeds the adjusted limit,
the power management function decreases
the last selected hob zone power limit
automatically, then the display flashes and
buzzer signal sounds. The power level of
the other cooking zones remain the same.
After turning on the hob, the default power
limit shows on the display for 4-5 seconds
as shown figure A
Figure A
5 different power limits are available (10 A ,
13A,15A,16A,32A)
Power Limit Required Cable
Size
10 A min 3G1,5mm²
13 A min 3G1,5mm²
15 A min 3G1,5mm²
16 A min 3G1,5mm²
32 A min 3G4 mm²
Setting the power limit;
IMPORTANT:I f you wish to select a power
limit which is higher than the default setting,
your electrical network (cable, plug,fuse,
etc.) must be checked and changed
if necessary by a qualified technician
according to local regulations.
After turning on the hob, in the first 60
seconds you can set the required power
limit by the following steps:
1. First you will see the default setting on
the display. (Figure A).
2. After the display goes off, turn on the
Bekijk gratis de handleiding van Sharp KH-6I37FT0K-EU, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sharp |
| Model | KH-6I37FT0K-EU |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 11713 MB |
