Severin WK 3480 handleiding
Handleiding
Je bekijkt pagina 13 van 84
13
142 x 208 mm
Control panel
ON/OFF button
This button is used to start and stop the kettle and cancel
functions.
+/– buttons
These buttons are used to adjust the temperature and
brewing time
‘Program’ button
This button is used to select the programs, individually
adjust tea preparation, and switch the beeps on and off
(Be-Silent function).
General remarks
∙ Connect the appliance to the mains. A beep signal is
heard and the current water temperature in the container
(≥ 20 °C) is shown in the display. The appliance is in
stand-by mode and ready for use.
∙ If the container is not placed on its base, the display
shows the error code E.
∙ When selecting temperatures below
100 °C, the heating process takes place in steps, to
ensure that the temperature selected is not exceeded.
∙ If the current temperature inside the container exceeds
the temperature selected, the appliance cannot be
started; in this case, a sequence of three beep signals is
heard.
∙ Temperatures below 40 °C cannot be selected.
Getting the appliance ready
∙ Remove the water container from its base; then turn the
lid insert anti-clockwise (UNLOCK) and take it off.
∙ Fill the water container with water to the desired level,
observing the Min and Max markings.
∙ Replace the lid insert and turn it clockwise (LOCK) until
it engages in the lock.
∙ Place the container back on its base.
∙ Insert the plug into a suitable wall socket. A beep signal
is heard and the display shows C, followed by the
current water temperature inside the container.
Heating water
∙ Select the desired temperature with the +/- buttons and
press the ON/OFF button to start preparation. Or just
press the ON/OFF button. The water will be heated to
100 °C.
∙ When the temperature is reached, you will hear beeps,
and the display will show the current water temperature.
Preparing tea with a programme
Tea program temperatures and brewing times
The optimal infusion times largely depend on the type of
tea used and on personal taste.
The tea programme provides for the following pre-set
temperatures and steeping times:
1 HERBAL herbal tea : 100 °C 6 mins
2 BLACK black tea : 100 °C 3 mins
3 OOLONG Ooolong tea : 90 °C 3 mins
4 WHITE white tea : 80 °C 3 mins
5 GREEN green tea : 70 °C 3 mins
∙ Keep the Program button pressed until the desired tea
program lights up.
∙ Conrm your selection with the ON/OFF button.
∙ The appliance will heat the water up to the preset
temperature.
∙ Once the preset temperature has been reached, the
heating element will switch off, you will hear beeps, and
the display will show the brewing time.
∙ Fit the tea lter into the water container as described
below under Fitting and removing the tea lter.
∙ Activate the preset brewing time with the ON/OFF
button. If a different brewing time is required, it can be
selected using the +/– buttons and then activated by
pressing the ON/OFF button. The brewing process is
indicated by an illuminated dot next to BREWING on the
display. The ON/OFF button lights up red.
∙ During the steeping process, the water is re-heated as
necessary to keep the temperature constant.
∙ Once the brewing time has elapsed, the beeps are
heard and the appliance goes into keep-warm mode.
Preparing tea using manual settings
∙ Press and hold the Program button for three seconds.
The display shows the last preset temperature, and the
blue LED lights up.
∙ Adjust the desired temperature using the +/– buttons.
∙ Conrm the selection by pressing the ON/OFF button.
∙ The kettle heats the water to the selected temperature.
∙ Once the preset temperature has been reached, the
heating element will switch off, you will hear three
beeps, and the appliance will go into keep-warm mode.
The Program button lights up blue.
∙ Fit the tea lter into the water container as described
below under Fitting and removing the tea lter.
∙ Select the desired brewing time (maximum 15 minutes)
with the +/– buttons.
∙ Activate the steeping time by pressing the ON/OFF
button. The steeping process is indicated by an
illuminated dot next to BREWING in the display. The
ON/OFF button lights up red. During the steeping
process, the water is re-heated as necessary to keep
the temperature at the selected level.
Bekijk gratis de handleiding van Severin WK 3480, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Severin |
| Model | WK 3480 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9157 MB |
