Sekonic RT-BR handleiding
Handleiding
Je bekijkt pagina 5 van 49
iv
■
Features of the RT-BR
To use the radio triggering mode of the L-858D after the transmitter is installed, the ash
unit must be equipped with a radio function supported by a specied manufacturer, or a
receiver supporting the radio function must be connected to the ash unit.
Using the radio triggering mode, ring a ash or adjusting the output power by yourself
can be easily accomplished remotely.
●
Take measurements by placing the product at the subject's position with the light
receptor (retracted lumisphere) facing toward the light sources of main light and ll light
directly. Adjust the measured values for the desired lighting ratio.
●
Turn on all light sources to measure the nal exposure, and point the lumisphere
(extended lumisphere) at the camera from the position of subject. (
P14, P27)
Note that this transmitter of RT-BR only supports the broncolor radio system.
Manufacturer Radio Studio/Lamp Function
broncolor Radio Studio Address : 1 to 99
Lamp Address : 1 to 40, ALL
Flash light triggering and output power
control, modeling lamp ON/OFF
■
Restrictions
There are some cautions and restrictions regarding the use of this product.
Please read and understand the following before using the product.
broncolor
：
Lamp
：
1
to
40
Light meter (with the
transmitter installed)
Light source (with a
receiver built-in/installed)
Camera
Lamp 1
Lamp 1
Lamp 2
Lamp 2
Subject
Figure 2
Subject
Figure 1
Bekijk gratis de handleiding van Sekonic RT-BR, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sekonic |
| Model | RT-BR |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5250 MB |