SEIKI SC-1300AU6DSS handleiding
Handleiding
Je bekijkt pagina 20 van 44
20
INSTALLATION (Cont.)
Connect to Water Supply Pipe and Power Supply
Connect the water inlet pipe to the faucet
The gasket shall be connected to the water inlet. Please use the new inlet pipe
attached. In order to ensure the quality, all dishwashers have been injected with
water for testing before leaving the factory. Therefore, there may be water in the
dishwasher, which is a normal phenomenon.
Inlet connection
1. The water supply pressure shall be between 30kPa and 1,000kPa.
2. Do not wear the thread when connecting the water inlet pipe with the valve.
3. If the water supply pressure exceeds 1,000kPa, please install a pressure
reducing device.
4. Turn on the faucet and check the connector for leakage.
5. Inspect pipes regularly, and change them if necessary.
6. Ensure that the pipes are not damaged or intertwined.
1. Check the rubber seal on both
sides of the hose. Insert the rubber
seal into the threaded joint of each
hose to prevent leakage.
3. Turn on the faucet to flush the
foreign matters (dirt, sand or sawdust)
in the water pipe after connecting the
water inlet hose to the faucet. Drain
the water into a bucket and check the
water temperature.
2. Connect the water supply hose to
the faucet by hand, and then tighten
it for 2/3 turn with pliers.
4. Connect the hose to the water
inlet valve tightly by hand, and then
tighten it for 2/3 turn with pliers.
5. Turn on the faucet to check
leakage. In case of water leakage,
please check steps 1-4.
Connection between water inlet pipe and faucet
Bekijk gratis de handleiding van SEIKI SC-1300AU6DSS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | SEIKI |
| Model | SC-1300AU6DSS |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 3622 MB |