Sealer Sales HL-M1120LD handleiding
Handleiding
Je bekijkt pagina 26 van 62
HL- M1120LD INSTRUCTION MANUAL(UPDATED: 2/27/24)
21
Figure 24. (1) Ink Roller, (2) Ink Roller Heating Block, (3) Swing Pole, (4) Adjusting Strut, (5) Ink Wheel Adjusting Device
4. Make Adjustments Between Printing Wheel and Silicone Wheel. The typesets/characters on
the printwheel should only touch the silicone wheel during the printing process. The characters
should not touch the silicone wheel at any other time. If the band sealer is used to seal relatively
thicker materials, the screw (Figure 25, Item #4) should be loosened. Rotate the eccentric sleeve
(Figure 25, Item #3) to ensure the characters/typesets slightly tough the silicone wheel's surface.
Refasten the screw after making adjustments.
Figure 25. (1) Printing Wheel, (2) Silicone Wheel, (3) Eccentric Sleeve, (4) Screw
5. Setting Printing Temperature. We recommend setting the ink temperature on the higher end.
Allow 5-10 minutes for the ink heating block and ink roller to reach the correct temperature.
Note:
If band sealer is not in use right away, do not leave ink roller in the unit while temperature
is on. This may result in the ink roller melting and producing messy print.
6. Adjusting Printing Position. The coding seat knob determines printing position on your
material. For example, if you want to print on the left side of your bag, turn the coding seat to its
Bekijk gratis de handleiding van Sealer Sales HL-M1120LD, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sealer Sales |
| Model | HL-M1120LD |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 15685 MB |
