Sealer Sales HL-M1120LD handleiding
Handleiding
Je bekijkt pagina 21 van 62
HL- M1120LD INSTRUCTION MANUAL(UPDATED: 2/27/24)
16
7. Place material on the guide (Figure 32, Item #5) and allow the band sealer to pull your material
through. Make sure your material is flat on the guide. While the material is moving through the
band sealer, do not push or pull the material as this will cause irregular sealing.
8. If the sealing belt is running off the guide wheels, make adjustments to the screws that are found
on the driven wheel seat (Figure 34, Item #28)
Figure 11. (1) Driven Wheel Seat (Adjusting Block), (2) Driven Wheel Seat (Adjusting Block), (3)/(4) Adjusting Screws, (5) Springs
9. Emergency Stop – Press the emergency stop to turn off the machine. In order to restart the
machine, you must release the emergency stop by turning the knob 120˚ clockwise.
10. To shut down, turn off the heater switch and allow the temperature of the machine to drop before
turning off the power and fan switches.
Following this shut down procedure will significantly
prolong the life of machine and sealing belts.
Sealing Optimization
1. Sealing performance can be adjusted with the sealing temperature and sealing speed. The higher
the speed the less exposure the material to heating blocks and therefore a higher temperature will
be required to seal the material.
2. Try a variety of different sealing temperatures and conveyor speeds to get the optimal seal for your
material.
Bekijk gratis de handleiding van Sealer Sales HL-M1120LD, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sealer Sales |
| Model | HL-M1120LD |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 15685 MB |
