Scotsman Brilliance SCN60 handleiding
Handleiding
Je bekijkt pagina 9 van 18
SCN60
User’s Manual
May 2011
Page 8
Plumbing - Pump Model
Drains
There are two types of ice machine models, one
that drains by gravity and one that has an internal
drain pump.
Drain Pump Model drain installation
1. Locate the coil of 3/8” ID plastic drain tubing
secured to the back of the unit.
2. Route the plastic drain tube from the back of
the unit to the drain connection point.
The drain connection point can be as high as
10 feet above the ice machine. The drain pump
includes a check valve to prevent re-pumping
water in the drain hose.
IMPORTANT NOTE: Often an air gap is required
by local codes between the ice maker drain tube
and the drain receptacle.
Water Supply
The recommended water supply tubing is ¼ inch
OD copper. Stainless steel ex or reinforced
PVC tube may also be used. Install an easily
accessible shut-o valve between the supply and
the unit. This shut-o valve should not be installed
behind the unit.
The water connection is at the back of the cabinet.
Connect using a compression tting, one is
supplied tied to the water inlet tube at the back
of the cabinet. When built in: Coil enough tubing
behind the machine so it can be pushed into the
cavity without kinking the tubing.
Connect Water Supply
Here, tting is supplied in
bag tied to tube.
Pump Drain
Discharge
Tubing
Bekijk gratis de handleiding van Scotsman Brilliance SCN60, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Scotsman |
| Model | Brilliance SCN60 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2937 MB |
