Scotsman Brilliance SCN60 handleiding
Handleiding
Je bekijkt pagina 11 van 18
SCN60
User’s Manual
May 2011
Page 10
Electrical and Start Up
The ice machine is supplied with a power cord. Do
not remove the grounding pin from the cord’s plug.
Do not use extension cords. Follow all codes.
Connect the machine to its own 115 volt, 15 amp
circuit.
1. If the electrical outlet for the ice maker is behind
the unit, plug in the unit.
2. Position the unit in the installation opening.
3. Turn on the water supply. Make sure that the
ice maker is plugged in and the power is on.
4. Slide unit into installation opening, paying
careful attention to water supply and drain
connections. Do not kink!
5. Pour a couple of quarts of water into the ice
storage bin; on drain pump equipped machines
the drain pump should start and water should
pump out. Check for leaks.
6. Replace the service access panel.
7. Level the unit as needed.
Installation check list:
1. Has the unit been connected to the proper
water supply?
2. Has the water supply been checked for leaks?
3. Has the unit been connected to a drain?
4. Has the drain been tested for ow and leaks?
5. Has the unit been connected to the proper
electrical supply?
6. Has the unit been leveled?
7. Have all packing materials been removed from
the machine?
8. Has the door covering been installed?
Initial Start Up
1. Turn on the water supply and check for leaks.
2. Switch on the electrical power.
3. Push and release the On/O switch to start the
machine. The Ice Making light next to the On/O
switch will glow Green. Warm air will ow out of
the left front grill.
It will take about 10 minutes for the ice machine to
begin dropping nugget ice into the storage bin. It
is normal for that ice to melt and ice will continue
to melt, but at a slower rate. It will take about 6 - 7
hours to ll up the ice storage bin. The bin holds
about 20 lb of ice when full.
Ice level control
The ice level control for the SCN60 is an
ultrasonic sensor, located above the ice storage
area. It is automatic and there is no adjustment to
make. When ice melts or is used, and the ice level
drops below a preset distance the control turns
the ice making system back on. It makes ice until
the preset level is reached. Placing your hand in
the unit to remove ice does not aect the ice level.
Bekijk gratis de handleiding van Scotsman Brilliance SCN60, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Scotsman |
| Model | Brilliance SCN60 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2937 MB |
