Scheppach HC24x handleiding
Handleiding
Je bekijkt pagina 26 van 288
www.scheppach.com
26
|
GB
m Attention!
Store the compressor only in dry locations that
are inaccessible for unauthorised persons. Do not
tilt the unit, only store it upright!
11.5 Transport
• Use the transport handle (1) to transport the device,
and drive the compressor with it.
• When lifting the compressor, note its weight (see
Technical data).
• Ensure that the load is well secured when transport-
ing the compressor in a motor vehicle.
11.6 Ordering spare parts
Please provide the following information when ordering
spare parts:
• Device type
• Device article number
• Device ID number
• Replacement part number of the required replace-
ment part
Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consumables.
Wearing parts*: Air lter
* may not be included in the scope of delivery!
Spare parts and accessories can be obtained from our Ser-
vice Centre. To do this, scan the QR code on the front page.
12. Disposal and recycling
Notes for packaging
The packaging materials are recycla-
ble. Please dispose of packaging in
an environmentally friendly manner.
Notes on the electrical and electronic equipment
act (ElektroG)
Waste electrical and electronic equipment
does not belong in household waste, but must
be collected and disposed of separately!
• Used batteries or rechargeable batteries that are
not installed permanently in the old device must be
removed non-destructively before disposal! Their
disposal is regulated by the battery act.
11.2 Maintaining the pressure vessel (g. 4)
m Attention! To ensure a long service life for the
pressure vessel (7), drain o the condensate after
each use by opening the drain screw (11).
• Release the vessel pressure at the quick-coupler (2)
beforehand. The drain screw is opened by turning it
counterclockwise (when looking at the screw on the
bottom of the compressor) so that the condensate
can be completely drained out of the pressure vessel.
• Tilt the product to the side to drain the condensation
water.
• Then close the drain screw again (turn clockwise).
• Check the pressure vessel for rust and damage
each time before use.
• The compressor shall not be operated if the pres-
sure vessel is damaged or rusty.
• If you discover damage, please contact the custom-
er service workshop.
m Attention!
The condensate from the pressure vessel contains oil
residue. Dispose of the condensate in an environmen-
tally friendly manner at a suitable collection point.
11.3 Safety valve (Fig. 1)
The safety valve (5) is set to the maximum permissible
pressure of the pressure vessel. It is not permitted to
adjust the safety valve or to remove the connection lock
(5.2) between the drain nut (5.1) and its cap (5.3).
Actuate the safety valve every 30 operating hours but
at least 3 times a year to ensure that it works when
required. Turn the perforated drain nut (5.1) anti-clock-
wise to open it, then pull the valve stem outwards by
hand via the perforated drain nut (5.1) to open the
safety valve outlet. Now, the valve audibly releases air.
Then turn the drain nut clockwise again to tighten.
11.4 Storage
Store the device and its accessories in a dark, dry and
frost-free place that is inaccessible to children. The op-
timum storage temperature lies between 5 and 30 ˚C.
m Attention!
Disconnect the mains plug, vent the device and all
connected compressed air tools. Store the com-
pressor in such a way that it cannot be used by un-
authorised persons.
Bekijk gratis de handleiding van Scheppach HC24x, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Scheppach |
| Model | HC24x |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 40205 MB |
