Scheppach DS940 handleiding

Niet gecategoriseerd

Scheppach

68 pagina's

PDF beschikbaar

Handleiding

 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58

Old devices must not be disposed of with house-

hold waste!

This symbol indicates that this product must not

be disposed of together with domestic waste in

compliance with the Directive (2012/19/EU) per-

taining to waste electrical and electronic equip-

ment (WEEE). This product must be disposed of at a

designated collection point. This can occur, for exam-

ple, by handing it in at an authorised collecting point

for the recycling of waste electrical and electronic

equipment. Improper handling of waste equipment

may have negative consequences for the environ-

ment and human health due to potentially hazardous

substances that are often contained in electrical and

electronic equipment. By properly disposing of this

product, you are also contributing to the effective use

of natural resources. You can obtain information on

collection points for waste equipment from your mu-

nicipal administration, public waste disposal authority,

an authorised body for the disposal of waste electrical

and electronic equipment or your waste disposal com-

pany.

13. Troubleshooting

Fault Possible cause Remedy

1. Power tool does

not start

Power supply interrupted Check power supply by connecting another

power tool

Power cord or plug defective Electrician must check the tool

Other electrical defect of the power tool Electrician must check the tool

2. Power tool

does not oper-

ate with full

power

Extension cord too long and/or cross-section

too small

Use extension cord with permissible length

and/or adequate cross-section

Power supply (e. g. generator) voltage too low Connect power tool to an appropriate

power supply

3. Poor operation

results

Sanding paper worn out Replace sanding paper

Abrasive plate worn out Replace abrasive plate by specialist

4. Considerable

dust formation

Brush edge (around the sanding disc) worn out Replace brush edge by specialist

Dust extraction not connected / switched on Connect / switch on dust extraction

Service information

Please note that the following parts of this product are

subject to normal or natural wear and that the follow-

ing parts are therefore also required for use as con-

sumables.

Wear parts*: Carbon brushes, grinding plates, brush

head, sanding paper

* Not necessarily included in the scope of delivery!

Bekijk gratis de handleiding van Scheppach DS940, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.