Scarlett SC-EC2000-S1M handleiding
Handleiding
Je bekijkt pagina 6 van 24
IM2025
6
4. Electric outlet must be properly grounded. The socket must be rated for at least
10A. Electrical plug and socket must always be dry to prevent electrical leakage.
Regularly check that the electrical plug is firmly connected to the outlet. Check the
plug in the following order: insert the plug into the socket. After half an hour, turn
off the convector and unplug the power cord, check if the plug is warm with the
hand. If the plug is heated to a temperature above 50 °C, in order to avoid
damage, accidents, fire, due to poor electrical contact replace the socket with help
of a specialist.
Attention!
It is forbidden to operate the convector in the electrical network without grounding.
8. OPERATION OF THE DEVICE
Turn the device
Connect the convector to the mains by plugging the power cord into the mains socket – the
indicator will light up.
The choice of the mode of heating power
Turn the power control knob so that the arrow on the device body coincides with one of the
power mode values: 1 – low power (750 W), 2 – medium power (1250 W), 3 – high power
(2000 W)
Setting the temperature
Turn the thermostat knob clockwise until it stops. When the room temperature reaches the
desired level, turn the thermostat knob counterclockwise until the appliance is switched off,
you will hear the click and the indicator will go out. The thermostat will maintain the set
temperature, periodically turning on and off the convector.
Switching off
Set the keys of the heating power mode switch to the "0" position and disconnect the
appliance from the electrical network.
9. CLEANING AND MAINTENANCE OF THE UNIT
The external body of the device must be regularly cleaned from dust and dirt, because this
affects the efficiency of its work.
Before cleaning, turn off the device and unplug it from the network, let it cool, then wipe its
body with a soft, slightly damp cloth. Then wipe it dry and allow the device to dry
completely. It is not recommended to use detergents, including detergents with abrasive
compounds to clean the body of the device. Do not damage the appliance with sharp
objects, because scratches on paint can cause rust.
The rear side of the convector must also be periodically cleaned from dust and dirt.
Cleaning should be carried out periodically to maintain the technical condition of the
convector and preserve its appearance for many years.
Bekijk gratis de handleiding van Scarlett SC-EC2000-S1M, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Scarlett |
| Model | SC-EC2000-S1M |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2518 MB |
