Saris Cycle Glide handleiding
Handleiding
Je bekijkt pagina 2 van 15
CEILING TRACK INSTALLATION: PARALLEL INSTALLATION:
1. 16 and 24 inches on-center are both standard spacing for ceiling joists.
Determine which applies to your installation.
2. Use a stud nder to locate and mark the center position of the ceiling joists
in the area you wish to install the CycleGlide.
3. Choose two ceiling joists to mount the ceiling tracks to. These joists should
be 16, 24, 32, or 48 inches apart.
4. It is recommended to use the widest spacing possible for best stability and
performance of system.
NOTE: This is the most critical step of your installation. Proper installation of the
ceiling tracks is important for the CycleGlide system to function properly and to
ensure its load-carrying capacity. Please read and follow directions carefully. An
extra set of hands may be helpful for this step.
1. Decide on the general location where you’d like to install the CycleGlide system.
NOTE: Keep the CycleGlide system at least 11” away from the wall parallel to
bicycle placement to prevent bicycle handlebars from hitting the wall. This is the
“nesting wall.”
2. Determine direction of the ceiling joists (if not exposed). Look for rows of nails
or screws holding up the drywall OR look in the attic and check visually for joist
direction.
NOTE: In some instances, ceiling joists in one area of the ceiling may not run in the
same direction as in other areas.
3. Determine your installation method (Figure 2A or 2B)
Parallel: CycleGlide ceiling tracks run parallel to the ceiling joists.
Perpendicular: CycleGlide ceiling tracks run perpendicular to the ceiling joists.
5. Bicycles may extend beyond the gliders that will run in the ceiling tracks.
When installing the ceiling tracks, make sure there will be sufcient room on
either end of the gliders so the bicycles will not interfere with walls or other
obstacles.
6. Once you’ve chosen two joists to mount the ceiling tracks to, mark a
straight line the length of the ceiling track (76”) on the ceiling joint along the
approximate center of each joist.
7. Using a hammer and nail, verify that the line made in the previous step is on a
ceiling joist. Do this on each end of each line.
8. Remembering to stay at least 11 inches away from the nesting wall, mount
the 76” ceiling tracks to the ceiling joist(s) centered directly on the lines made in
the previous step using the 2” wood screws provided. Leave the screws slightly
loose until all screws have been installed.
Bekijk gratis de handleiding van Saris Cycle Glide, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Saris |
| Model | Cycle Glide |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2841 MB |
