Handleiding
Je bekijkt pagina 25 van 35
Gas conversion
Gas conversion _ 24
Installation Of Appliance
Installation of the appliance
Injector
Control handle
Tap
Sealing ring
Tap
2 - Adjustment of minimum level of the flame
Take precautions on the operations and adjustments to be carried out when
converting from one gas to another.
All work must be carried out by a qualified technician.
Before you begin, turn off the gas and electricity supply to the appliance.
1 - Change the injector of the burners.
Remove the pan support, Burner lid and Flame spreader.
Unscrew the injector using a 7 mm box spanner and replace it with
the stipulated injector for new gas supply. ( see Page 21.)
Carefully reassemble the all components.
After injectors are replaced, it is advisable to strongly tighten the
injector in place.
By-pass screw
Turn the taps down to minimum.
Remove the control hands from taps.
Adjusting by pass screw
- For converting ‘natural’ gas G20 into ‘liquid’
gas G30 the screw must be screws down
fully tight
- For converting back from G30 into G20, please
rotate the screw in opposite direction to adjust
the minimum level
- Finally check the flame does not go out when
quickly turning the tap from the maximum position
to the minimum position.
Install the control handles on the taps.
Do not dismantle the tap shaft :
in the event of a malfunction,
change the whole tap.
Before placing the burners
back on the top place, make sure
that the injector is not blocked.
A full operational test and a test
for possible leakages must be
carried out after gas conversion.
(such as soap water or gas
detector)
After completing conversion,
a qualified technician or installer
has to mark “V" on the right gas
category to match with the
setting in rating plate.
Remove the previous setting“V” mark.
Do not completely remove the valve set screw
from the valve stem.The valve set screw is an
integral part of the gas valve assembly.Removing
the valve set screw will cause gas to leak.
South Africa
220-240V~ 50-60Hz, Pmax 1W
LPG(Butane)
S/N:
Built-in Gas Hob
Destination
Cat.: II2H3+
Model:
ΣQn LPG(Butane): 2.8-3.0kPa, 9.6kW, 699g/h
ΣQn NG(Methane): 2.0kPa, 9.6kW, 0.912m³/h
Bekijk gratis de handleiding van Samsung NA75D3030AS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Samsung |
| Model | NA75D3030AS |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 3342 MB |
