Handleiding
Je bekijkt pagina 24 van 35
Gas connection
e d a
The gas inlet connection fitting is 1/2 inch female thread.
Gas distributed by pipe ; natural gas, propane-air gas or butane-air gas.
For your safety, you must choose from the three following connection options.
If you need to adiust the angle of the elbow, please select to turn the air pipe connector
connected with the elbow, which can turn. lf it is necessary to turn the elbow, use a
suitable wrench and the torque used in the tightening process should not exceed 10N.m.
Warning
Do not turn the elbow !
This appliance must be installed and connected in accordance with installation
regulations in force in the country in which the appliance is to be used.
This appliance is supplied to run on natural gas only and cannot be used on
any other type of gas without modification. Conversion for use on LPG and
other gases must only be undertaken by a qualified person.
Connection with a rigid pipe made from copper and with
screw-on mechanical connectors.
Make the connection directly to the end of the elbow fitted on
the appliance.
Connection using flexible undulated metal tube with
screw-on connectors.(Fig.A)
You can use a flexible stainless steel pipe available from your
after sales service department.
Connection using flexible tube with screw-on connectors.(Fig.B)
These tubes must not exceed 2 meters in length and must be
accessible along their entire length.
Gas supplied by tank or cylinder (butane/propane)
For the user's safety, we advise the connection to be made
with a rigid pipe if this is possible, using a flexible undulated
metal tube with scerw-on connectors(maximum length
2meters)(Fig.A)
For an existing installation, where it is not possible to fit a
reinforced, braided, flexible gas hose, the connection can be
made with a flexible gas hose(maximum length 2meters),
with two clamps.
One on the connector, and the other on the pressure
regulator, and a gasket should be fitted between the
connector and the hob's elbow.(Fig.B)
You can obtain the connector and the gasket from your After-Sales Service.
In France, you must use a tube or a pipe featuring the“NF Gaz”logo.
You should check the local installation regulation regarding the permitted
the use of certain type of flexible gas tube.
A full operational test and a test for possible leakages must be carried out
by the fitter after installation.
Access to the whole length of the connection hose must be possible and
the gas hose must be replaced before its use before the end of service life
(indicated on the hose).
23 _ Gas connection
Air pipe
connector
Fig.A Fig.B
Elbow
Gasket
Air pipe
connector
Elbow
Gasket
Fig.A Fig.B
Clamp
Bekijk gratis de handleiding van Samsung NA75D3030AS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Samsung |
| Model | NA75D3030AS |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 3342 MB |
