Handleiding
Je bekijkt pagina 23 van 35
Installation of the appliance
H
H
H
H
Bottom viewNA64D3010AS(Stainless)
NA64D3030AK(Glass)
NA75D3030AS(Stainless)
H
H
H
H
Installation of the appliance
1.Place the bracket(B) over the holes that match the size
of the screws.There are one set of screw holes in each
corner of the hob(H).
Slightly tighten a screw(C)through the bracket(B)so
that the bracket is attached to the hob, but so that you
can still adjust the position.
2. Carefully turn the hob back over and then gently lower it
into the aperture hole that you have cut out.
3. On the underneath of the hob, adjust the brackets into a
position that is suitable for your worktop.
Then fully tighten the screws(C) to secure the hob into
position.
(A) SEALING STRIP
(C) SCREW (B) BRACKET
Do not use a silicon sealant to seal the
appliance against the aperture.
This will make it difficult to remove the
appliance from the aperture in future,
particularly if it needs to be serviced.
The thickness of the sponge in stainless model is 1.5mm.
The thickness of the sponge in glass model is 3.0mm
(A)The width of the sponge is 10mm
(B)The width of the sponge is 20mm
1.Remove the pan supports, the burner lid and flame spreader
and carefully turn the appliance upside down and place it on a
cushioned mat.
Take care that the ignition devices and flame supervision devices
are not damaged in this operation.
2. Apply the sponge provided around the edge of the appliance
3. Do not leave a gap in the sealing agent or overlap the thickness.
Sponge
510*20
Sponge
1000*10
Sponge
510*20
Sponge
1000*10
Sponge
(A)
(B)
(B)
(A)
Installation of the appliance _ 22
Bekijk gratis de handleiding van Samsung NA64D3010AK, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Samsung |
| Model | NA64D3010AK |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 3342 MB |
