Handleiding
Je bekijkt pagina 14 van 84
11
Clean filter
Spring
fastener
Spring
fastener
2.
Clean filter
Use clear water to wash it or dust catcher to
clean it. If the filter is very dirty (such as grease),
use warm water (45℃) dissolved with neutral
detergent to clean it, and then put it at the shady
place to dry it.
1.
Remove filter
Press the spring fasteners at both sides in the
direction indicated by the arrows.
Meanwhile, lift up the filter so that it is separat-
ed from the fasteners.
Pull the filter forward and remove it.
Clean and maintenance
■
2.
WARNING
WARNING
■
■
■
Error Code
Error code
F2
Please contact qualified professionals for
service.
NOTE
●
E8
Troubleshooting
C5, F0, F1,
U8, H6, H3,
Notice for recovery
E1, E5, E6,
1.
3.
Install filter
After
cleaning, reinstall the filter in reverse order.
Push it along the guide rails at both sides and
then press the left and right edges of the filter.
Refit the filter in the direction indicated by the
arrows.
If there're other error codes, please contact qu-
alified professionals for service.
Clean surface of indoor unit
When the surface of indoor unit is dirty, it is recomm-
ended to use a soft dry cloth or wet cloth to wipe it.
The filter should be cleaned every three months .
If there is much dust in the operation environme-
nt, clean frequency can be increased.
After removing the filter, do not touch fins to
avoid injury.
Do not use fire or hair dryer to dry the filter to
avoid deformation or fire hazard.
Many packing materials are recyclable mate-
rials. Please dispose them in appropriat e
recycling unit.
If you want to dispose the air conditioner, please
contact local dealer or consultant service center
for the correct disposal method.
When air conditioner status is abnormal, tempe-
rature indicator on indoor unit will blink to display
corresponding error code. Please refer to below
list for identification of error code.
NOTICE
●
It can be eliminated after restarting the unit.
If not, please contact qualified professionals
for service.
NOTICE: Checking after use-season
4.
1.
1.
2.
3.
2.
NOTICE: Checking before use-season
Do not remove the panel when cleaning it.
■
Turn off the air conditioner and disconnect the
power before cleaning the air conditioner to av-
oid electric shock.
■
Do not wash the air conditioner with water to
avoid electric shock.
■
Do not use volatile liquid to clean the air
conditioner.
Do not use liquid or corrosive detergent to clean
the appliance and do not splash water or other
liquid onto it , otherwise, it may damage the
plastic components , even cause electric shock.
5.
Disconnect power supply.
Clean filter and indoor unit’s panel.
Check whether mounting bracke t for outdo
or
unit is damaged or corroded. If yes, please
contact dealer.
unit is damaged or corroded . If yes, please
contact dealer.
Check whether drainage pipe is damaged.
Check whether air inlets and air outlets are bl-
ocked.
Check whether air switch, plug and socket are
in good condition.
3.Check whether filter is clean.
Check whether mounting bracket for outdoor
Bekijk gratis de handleiding van Samsung AR24CRHGAWK, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Samsung |
| Model | AR24CRHGAWK |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 13575 MB |
